[media] adv7604: add hdmi driver strength adjustment

The driver strength is board dependent, so set it from the platform_data.

Signed-off-by: Mikhail Khelik <mkhelik@cisco.com>
Signed-off-by: Hans Verkuil <hans.verkuil@cisco.com>
Signed-off-by: Mauro Carvalho Chehab <m.chehab@samsung.com>

drivers/media/i2c/adv7604.c

@@ -1942,7 +1942,12 @@ static int adv7604_core_init(struct v4l2_subdev *sd)
 	/* TODO from platform data */
 	cp_write(sd, 0x69, 0x30);   /* Enable CP CSC */
 	io_write(sd, 0x06, 0xa6);   /* positive VS and HS */
-	io_write(sd, 0x14, 0x7f);   /* Drive strength adjusted to max */
+
+	/* Adjust drive strength */
+	io_write(sd, 0x14, 0x40 | pdata->dr_str_data << 4 |
+				pdata->dr_str_clk << 2 |
+				pdata->dr_str_sync);
+
 	cp_write(sd, 0xba, (pdata->hdmi_free_run_mode << 1) | 0x01); /* HDMI free run */
 	cp_write(sd, 0xf3, 0xdc); /* Low threshold to enter/exit free run mode */
 	cp_write(sd, 0xf9, 0x23); /*  STDI ch. 1 - LCVS change threshold -

include/media/adv7604.h

@@ -78,6 +78,12 @@ enum adv7604_op_format_sel {
 	ADV7604_OP_FORMAT_SEL_SDR_ITU656_24_MODE2 = 0x8a,
 };
 
+enum adv7604_drive_strength {
+	ADV7604_DR_STR_MEDIUM_LOW = 1,
+	ADV7604_DR_STR_MEDIUM_HIGH = 2,
+	ADV7604_DR_STR_HIGH = 3,
+};
+
 /* Platform dependent definition */
 struct adv7604_platform_data {
 	/* connector - HDMI or DVI? */
@@ -110,6 +116,11 @@ struct adv7604_platform_data {
 	unsigned replicate_av_codes:1;
 	unsigned invert_cbcr:1;
 
+	/* IO register 0x14 */
+	enum adv7604_drive_strength dr_str_data;
+	enum adv7604_drive_strength dr_str_clk;
+	enum adv7604_drive_strength dr_str_sync;
+
 	/* IO register 0x30 */
 	unsigned output_bus_lsb_to_msb:1;