drm: Turn bus flags macros into an enum

This allows nicer kerneldoc with an easy way to reference the enum and
the values.

Signed-off-by: Laurent Pinchart <laurent.pinchart@ideasonboard.com>
Signed-off-by: Tomi Valkeinen <tomi.valkeinen@ti.com>

include/drm/drm_connector.h

@@ -205,6 +205,68 @@ enum drm_panel_orientation {
 	DRM_MODE_PANEL_ORIENTATION_RIGHT_UP,
 };
 
+/**
+ * enum drm_bus_flags - bus_flags info for &drm_display_info
+ *
+ * This enum defines signal polarities and clock edge information for signals on
+ * a bus as bitmask flags.
+ *
+ * The clock edge information is conveyed by two sets of symbols,
+ * DRM_BUS_FLAGS_*_DRIVE_\* and DRM_BUS_FLAGS_*_SAMPLE_\*. When this enum is
+ * used to describe a bus from the point of view of the transmitter, the
+ * \*_DRIVE_\* flags should be used. When used from the point of view of the
+ * receiver, the \*_SAMPLE_\* flags should be used. The \*_DRIVE_\* and
+ * \*_SAMPLE_\* flags alias each other, with the \*_SAMPLE_POSEDGE and
+ * \*_SAMPLE_NEGEDGE flags being equal to \*_DRIVE_NEGEDGE and \*_DRIVE_POSEDGE
+ * respectively. This simplifies code as signals are usually sampled on the
+ * opposite edge of the driving edge. Transmitters and receivers may however
+ * need to take other signal timings into account to convert between driving
+ * and sample edges.
+ *
+ * @DRM_BUS_FLAG_DE_LOW:		The Data Enable signal is active low
+ * @DRM_BUS_FLAG_DE_HIGH:		The Data Enable signal is active high
+ * @DRM_BUS_FLAG_PIXDATA_POSEDGE:	Legacy value, do not use
+ * @DRM_BUS_FLAG_PIXDATA_NEGEDGE:	Legacy value, do not use
+ * @DRM_BUS_FLAG_PIXDATA_DRIVE_POSEDGE:	Data is driven on the rising edge of
+ *					the pixel clock
+ * @DRM_BUS_FLAG_PIXDATA_DRIVE_NEGEDGE:	Data is driven on the falling edge of
+ *					the pixel clock
+ * @DRM_BUS_FLAG_PIXDATA_SAMPLE_POSEDGE: Data is sampled on the rising edge of
+ *					the pixel clock
+ * @DRM_BUS_FLAG_PIXDATA_SAMPLE_NEGEDGE: Data is sampled on the falling edge of
+ *					the pixel clock
+ * @DRM_BUS_FLAG_DATA_MSB_TO_LSB:	Data is transmitted MSB to LSB on the bus
+ * @DRM_BUS_FLAG_DATA_LSB_TO_MSB:	Data is transmitted LSB to MSB on the bus
+ * @DRM_BUS_FLAG_SYNC_POSEDGE:		Legacy value, do not use
+ * @DRM_BUS_FLAG_SYNC_NEGEDGE:		Legacy value, do not use
+ * @DRM_BUS_FLAG_SYNC_DRIVE_POSEDGE:	Sync signals are driven on the rising
+ *					edge of the pixel clock
+ * @DRM_BUS_FLAG_SYNC_DRIVE_NEGEDGE:	Sync signals are driven on the falling
+ *					edge of the pixel clock
+ * @DRM_BUS_FLAG_SYNC_SAMPLE_POSEDGE:	Sync signals are sampled on the rising
+ *					edge of the pixel clock
+ * @DRM_BUS_FLAG_SYNC_SAMPLE_NEGEDGE:	Sync signals are sampled on the falling
+ *					edge of the pixel clock
+ */
+enum drm_bus_flags {
+	DRM_BUS_FLAG_DE_LOW = BIT(0),
+	DRM_BUS_FLAG_DE_HIGH = BIT(1),
+	DRM_BUS_FLAG_PIXDATA_POSEDGE = BIT(2),
+	DRM_BUS_FLAG_PIXDATA_NEGEDGE = BIT(3),
+	DRM_BUS_FLAG_PIXDATA_DRIVE_POSEDGE = DRM_BUS_FLAG_PIXDATA_POSEDGE,
+	DRM_BUS_FLAG_PIXDATA_DRIVE_NEGEDGE = DRM_BUS_FLAG_PIXDATA_NEGEDGE,
+	DRM_BUS_FLAG_PIXDATA_SAMPLE_POSEDGE = DRM_BUS_FLAG_PIXDATA_NEGEDGE,
+	DRM_BUS_FLAG_PIXDATA_SAMPLE_NEGEDGE = DRM_BUS_FLAG_PIXDATA_POSEDGE,
+	DRM_BUS_FLAG_DATA_MSB_TO_LSB = BIT(4),
+	DRM_BUS_FLAG_DATA_LSB_TO_MSB = BIT(5),
+	DRM_BUS_FLAG_SYNC_POSEDGE = BIT(6),
+	DRM_BUS_FLAG_SYNC_NEGEDGE = BIT(7),
+	DRM_BUS_FLAG_SYNC_DRIVE_POSEDGE = DRM_BUS_FLAG_SYNC_POSEDGE,
+	DRM_BUS_FLAG_SYNC_DRIVE_NEGEDGE = DRM_BUS_FLAG_SYNC_NEGEDGE,
+	DRM_BUS_FLAG_SYNC_SAMPLE_POSEDGE = DRM_BUS_FLAG_SYNC_NEGEDGE,
+	DRM_BUS_FLAG_SYNC_SAMPLE_NEGEDGE = DRM_BUS_FLAG_SYNC_POSEDGE,
+};
+
 /**
  * struct drm_display_info - runtime data about the connected sink
  *
@@ -280,52 +342,10 @@ struct drm_display_info {
 	 */
 	unsigned int num_bus_formats;
 
-#define DRM_BUS_FLAG_DE_LOW		(1<<0)
-#define DRM_BUS_FLAG_DE_HIGH		(1<<1)
-
-/*
- * Don't use those two flags directly, use the DRM_BUS_FLAG_PIXDATA_DRIVE_*
- * and DRM_BUS_FLAG_PIXDATA_SAMPLE_* variants to qualify the flags explicitly.
- * The DRM_BUS_FLAG_PIXDATA_SAMPLE_* flags are defined as the opposite of the
- * DRM_BUS_FLAG_PIXDATA_DRIVE_* flags to make code simpler, as signals are
- * usually to be sampled on the opposite edge of the driving edge.
- */
-#define DRM_BUS_FLAG_PIXDATA_POSEDGE	(1<<2)
-#define DRM_BUS_FLAG_PIXDATA_NEGEDGE	(1<<3)
-
-/* Drive data on rising edge */
-#define DRM_BUS_FLAG_PIXDATA_DRIVE_POSEDGE	DRM_BUS_FLAG_PIXDATA_POSEDGE
-/* Drive data on falling edge */
-#define DRM_BUS_FLAG_PIXDATA_DRIVE_NEGEDGE	DRM_BUS_FLAG_PIXDATA_NEGEDGE
-/* Sample data on rising edge */
-#define DRM_BUS_FLAG_PIXDATA_SAMPLE_POSEDGE	DRM_BUS_FLAG_PIXDATA_NEGEDGE
-/* Sample data on falling edge */
-#define DRM_BUS_FLAG_PIXDATA_SAMPLE_NEGEDGE	DRM_BUS_FLAG_PIXDATA_POSEDGE
-
-/* data is transmitted MSB to LSB on the bus */
-#define DRM_BUS_FLAG_DATA_MSB_TO_LSB	(1<<4)
-/* data is transmitted LSB to MSB on the bus */
-#define DRM_BUS_FLAG_DATA_LSB_TO_MSB	(1<<5)
-
-/*
- * Similarly to the DRM_BUS_FLAG_PIXDATA_* flags, don't use these two flags
- * directly, use one of the DRM_BUS_FLAG_SYNC_(DRIVE|SAMPLE)_* instead.
- */
-#define DRM_BUS_FLAG_SYNC_POSEDGE	(1<<6)
-#define DRM_BUS_FLAG_SYNC_NEGEDGE	(1<<7)
-
-/* Drive sync on rising edge */
-#define DRM_BUS_FLAG_SYNC_DRIVE_POSEDGE		DRM_BUS_FLAG_SYNC_POSEDGE
-/* Drive sync on falling edge */
-#define DRM_BUS_FLAG_SYNC_DRIVE_NEGEDGE		DRM_BUS_FLAG_SYNC_NEGEDGE
-/* Sample sync on rising edge */
-#define DRM_BUS_FLAG_SYNC_SAMPLE_POSEDGE	DRM_BUS_FLAG_SYNC_NEGEDGE
-/* Sample sync on falling edge */
-#define DRM_BUS_FLAG_SYNC_SAMPLE_NEGEDGE	DRM_BUS_FLAG_SYNC_POSEDGE
-
 	/**
 	 * @bus_flags: Additional information (like pixel signal polarity) for
-	 * the pixel data on the bus, using DRM_BUS_FLAGS\_ defines.
+	 * the pixel data on the bus, using &enum drm_bus_flags values
+	 * DRM_BUS_FLAGS\_.
 	 */
 	u32 bus_flags;