[PATCH] ide: restore support for AEC6280M cards in aec62xx.c

This patch adds missing initialization sequence, necessary to get the
"Macintosh" version of AEC6280 cards to work in Linux.  Without this patch,
the driver hangs for several minutes trying to initialize the card and the
kernel is left in an unstable state.  This patch has been tested fine on
ppc and i386.

Signed-off-by: Thibaut VARENE <varenet@parisc-linux.org>
Acked-by: Bartlomiej Zolnierkiewicz <B.Zolnierkiewicz@elka.pw.edu.pl>
Cc: Alan Cox <alan@lxorguk.ukuu.org.uk>
Signed-off-by: Andrew Morton <akpm@osdl.org>
Signed-off-by: Linus Torvalds <torvalds@osdl.org>

drivers/ide/pci/aec62xx.c

@@ -262,6 +262,21 @@ static unsigned int __devinit init_chipset_aec62xx(struct pci_dev *dev, const ch
 	else
 		pci_set_drvdata(dev, (void *) aec6xxx_34_base);
 
+	/* These are necessary to get AEC6280 Macintosh cards to work */
+	if ((dev->device == PCI_DEVICE_ID_ARTOP_ATP865) ||
+	    (dev->device == PCI_DEVICE_ID_ARTOP_ATP865R)) {
+		u8 reg49h = 0, reg4ah = 0;
+		/* Clear reset and test bits.  */
+		pci_read_config_byte(dev, 0x49, &reg49h);
+		pci_write_config_byte(dev, 0x49, reg49h & ~0x30);
+		/* Enable chip interrupt output.  */
+		pci_read_config_byte(dev, 0x4a, &reg4ah);
+		pci_write_config_byte(dev, 0x4a, reg4ah & ~0x01);
+		/* Enable burst mode. */
+		pci_read_config_byte(dev, 0x4a, &reg4ah);
+		pci_write_config_byte(dev, 0x4a, reg4ah | 0x80);
+	}
+
 	return dev->irq;
 }