PCI: tegra: Support MSI 64-bit addressing

The MSI target address can reside beyond the 32-bit boundary on devices
with more than 2 GiB of system memory.  The PCI host bridge on Tegra can
easily support 64-bit addresses, so make sure to pass the upper 32 bits of
the target address to endpoints when allocating MSI entries.

Signed-off-by: Thierry Reding <treding@nvidia.com>
Signed-off-by: Bjorn Helgaas <bhelgaas@google.com>
Acked-by: Stephen Warren <swarren@nvidia.com>

drivers/pci/host/pci-tegra.c

@@ -235,6 +235,7 @@ struct tegra_msi {
 	struct irq_domain *domain;
 	unsigned long pages;
 	struct mutex lock;
+	u64 phys;
 	int irq;
 };
 
@@ -1448,9 +1449,8 @@ static int tegra_msi_setup_irq(struct msi_controller *chip,
 
 	irq_set_msi_desc(irq, desc);
 
-	msg.address_lo = virt_to_phys((void *)msi->pages);
-	/* 32 bit address only */
-	msg.address_hi = 0;
+	msg.address_lo = lower_32_bits(msi->phys);
+	msg.address_hi = upper_32_bits(msi->phys);
 	msg.data = hwirq;
 
 	pci_write_msi_msg(irq, &msg);
@@ -1499,7 +1499,6 @@ static int tegra_pcie_enable_msi(struct tegra_pcie *pcie)
 	const struct tegra_pcie_soc *soc = pcie->soc;
 	struct tegra_msi *msi = &pcie->msi;
 	struct device *dev = pcie->dev;
-	unsigned long base;
 	int err;
 	u32 reg;
 
@@ -1533,10 +1532,10 @@ static int tegra_pcie_enable_msi(struct tegra_pcie *pcie)
 
 	/* setup AFI/FPCI range */
 	msi->pages = __get_free_pages(GFP_KERNEL, 0);
-	base = virt_to_phys((void *)msi->pages);
+	msi->phys = virt_to_phys((void *)msi->pages);
 
-	afi_writel(pcie, base >> soc->msi_base_shift, AFI_MSI_FPCI_BAR_ST);
-	afi_writel(pcie, base, AFI_MSI_AXI_BAR_ST);
+	afi_writel(pcie, msi->phys >> soc->msi_base_shift, AFI_MSI_FPCI_BAR_ST);
+	afi_writel(pcie, msi->phys, AFI_MSI_AXI_BAR_ST);
 	/* this register is in 4K increments */
 	afi_writel(pcie, 1, AFI_MSI_BAR_SZ);