ixgbe: Check DDM existence in transceiver before access

[ Upstream commit 655c91414579d7bb115a4f7898ee726fc18e0984 ]

Some transceivers may comply with SFF-8472 but not implement the Digital
Diagnostic Monitoring (DDM) interface described in it. The existence of
such area is specified by bit 6 of byte 92, set to 1 if implemented.

Currently, due to not checking this bit ixgbe fails trying to read SFP
module's eeprom with the follow message:

ethtool -m enP51p1s0f0
Cannot get Module EEPROM data: Input/output error

Because it fails to read the additional 256 bytes in which it was assumed
to exist the DDM data.

This issue was noticed using a Mellanox Passive DAC PN 01FT738. The eeprom
data was confirmed by Mellanox as correct and present in other Passive
DACs in from other manufacturers.

Signed-off-by: "Mauro S. M. Rodrigues" <maurosr@linux.vnet.ibm.com>
Reviewed-by: Jesse Brandeburg <jesse.brandeburg@intel.com>
Tested-by: Andrew Bowers <andrewx.bowers@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>
Signed-off-by: Sasha Levin <sashal@kernel.org>

drivers/net/ethernet/intel/ixgbe/ixgbe_ethtool.c

@@ -3223,7 +3223,8 @@ static int ixgbe_get_module_info(struct net_device *dev,
 		page_swap = true;
 	}
 
-	if (sff8472_rev == IXGBE_SFF_SFF_8472_UNSUP || page_swap) {
+	if (sff8472_rev == IXGBE_SFF_SFF_8472_UNSUP || page_swap ||
+	    !(addr_mode & IXGBE_SFF_DDM_IMPLEMENTED)) {
 		/* We have a SFP, but it does not support SFF-8472 */
 		modinfo->type = ETH_MODULE_SFF_8079;
 		modinfo->eeprom_len = ETH_MODULE_SFF_8079_LEN;

drivers/net/ethernet/intel/ixgbe/ixgbe_phy.h

@@ -45,6 +45,7 @@
 #define IXGBE_SFF_SOFT_RS_SELECT_10G		0x8
 #define IXGBE_SFF_SOFT_RS_SELECT_1G		0x0
 #define IXGBE_SFF_ADDRESSING_MODE		0x4
+#define IXGBE_SFF_DDM_IMPLEMENTED		0x40
 #define IXGBE_SFF_QSFP_DA_ACTIVE_CABLE		0x1
 #define IXGBE_SFF_QSFP_DA_PASSIVE_CABLE		0x8
 #define IXGBE_SFF_QSFP_CONNECTOR_NOT_SEPARABLE	0x23