iwlwifi: clear all the stop_queue flag after load firmware

All the queues are awake and ready to use after loading firmware,
for firmware reload case, if any queues was stopped before
reload, mac80211 will wake those queues after restart hardware, so make
sure all the flag used to keep track of the queue status are
reset correctly.

Signed-off-by: Wey-Yi Guy <wey-yi.w.guy@intel.com>
Signed-off-by: Reinette Chatre <reinette.chatre@intel.com>

drivers/net/wireless/iwlwifi/iwl-4965.c

@@ -581,6 +581,11 @@ static int iwl4965_alive_notify(struct iwl_priv *priv)
 
 	iwl4965_set_wr_ptrs(priv, IWL_CMD_QUEUE_NUM, 0);
 
+	/* make sure all queue are not stopped */
+	memset(&priv->queue_stopped[0], 0, sizeof(priv->queue_stopped));
+	for (i = 0; i < 4; i++)
+		atomic_set(&priv->queue_stop_count[i], 0);
+
 	/* reset to 0 to enable all the queue first */
 	priv->txq_ctx_active_msk = 0;
 	/* Map each Tx/cmd queue to its corresponding fifo */

drivers/net/wireless/iwlwifi/iwl-5000.c

@@ -648,6 +648,11 @@ int iwl5000_alive_notify(struct iwl_priv *priv)
 
 	iwl5000_set_wr_ptrs(priv, IWL_CMD_QUEUE_NUM, 0);
 
+	/* make sure all queue are not stopped */
+	memset(&priv->queue_stopped[0], 0, sizeof(priv->queue_stopped));
+	for (i = 0; i < 4; i++)
+		atomic_set(&priv->queue_stop_count[i], 0);
+
 	/* reset to 0 to enable all the queue first */
 	priv->txq_ctx_active_msk = 0;
 	/* map qos queues to fifos one-to-one */