OMAP: GPIO: Avoid generating extra IRQs

It is possible for GPIO IRQ lines configured with
falling edge triggering only to get IRQs at the
rising edge upon the exit of offmode. And vice
versa. Prevent such IRQs to arrive by generating
the IRQ obeying the detection scheme.

Signed-off-by: Eero Nurkkala <ext-eero.nurkkala@nokia.com>
Signed-off-by: Tony Lindgren <tony@atomide.com>

arch/arm/plat-omap/gpio.c

@@ -1895,7 +1895,7 @@ void omap2_gpio_resume_after_retention(void)
 		return;
 	for (i = 0; i < gpio_bank_count; i++) {
 		struct gpio_bank *bank = &gpio_bank[i];
-		u32 l;
+		u32 l, gen, gen0, gen1;
 
 		if (!(bank->enabled_non_wakeup_gpios))
 			continue;
@@ -1916,14 +1916,33 @@ void omap2_gpio_resume_after_retention(void)
 #endif
 		l ^= bank->saved_datain;
 		l &= bank->non_wakeup_gpios;
-		if (l) {
+
+		/*
+		 * No need to generate IRQs for the rising edge for gpio IRQs
+		 * configured with falling edge only; and vice versa.
+		 */
+		gen0 = l & bank->saved_fallingdetect;
+		gen0 &= bank->saved_datain;
+
+		gen1 = l & bank->saved_risingdetect;
+		gen1 &= ~(bank->saved_datain);
+
+		/* FIXME: Consider GPIO IRQs with level detections properly! */
+		gen = l & (~(bank->saved_fallingdetect) &
+				~(bank->saved_risingdetect));
+		/* Consider all GPIO IRQs needed to be updated */
+		gen |= gen0 | gen1;
+
+		if (gen) {
 			u32 old0, old1;
 #if defined(CONFIG_ARCH_OMAP24XX) || defined(CONFIG_ARCH_OMAP34XX) || \
 			defined(CONFIG_ARCH_OMAP4)
 			old0 = __raw_readl(bank->base + OMAP24XX_GPIO_LEVELDETECT0);
 			old1 = __raw_readl(bank->base + OMAP24XX_GPIO_LEVELDETECT1);
-			__raw_writel(old0 | l, bank->base + OMAP24XX_GPIO_LEVELDETECT0);
-			__raw_writel(old1 | l, bank->base + OMAP24XX_GPIO_LEVELDETECT1);
+			__raw_writel(old0 | gen, bank->base +
+					OMAP24XX_GPIO_LEVELDETECT0);
+			__raw_writel(old1 | gen, bank->base +
+					OMAP24XX_GPIO_LEVELDETECT1);
 			__raw_writel(old0, bank->base + OMAP24XX_GPIO_LEVELDETECT0);
 			__raw_writel(old1, bank->base + OMAP24XX_GPIO_LEVELDETECT1);
 #endif