net: ethernet: ti: cpsw: fix packet leaking in dual_mac mode

In dual_mac mode packets arrived on one port should not be forwarded by
switch hw to another port. Only Linux Host can forward packets between
ports. The below test case (reported in [1]) shows that packet arrived on
one port can be leaked to anoter (reproducible with dual port evms):
 - connect port 1 (eth0) to linux Host 0 and run tcpdump or Wireshark
 - connect port 2 (eth1) to linux Host 1 with vlan 1 configured
 - ping <IPx> from Host 1 through vlan 1 interface.
ARP packets will be seen on Host 0.

Issue happens because dual_mac mode is implemnted using two vlans: 1 (Port
1+Port 0) and 2 (Port 2+Port 0), so there are vlan records created for for
each vlan. By default, the ALE will find valid vlan record in its table
when vlan 1 tagged packet arrived on Port 2 and so forwards packet to all
ports which are vlan 1 members (like Port.

To avoid such behaviorr the ALE VLAN ID Ingress Check need to be enabled
for each external CPSW port (ALE_PORTCTLn.VID_INGRESS_CHECK) so ALE will
drop ingress packets if Rx port is not VLAN member.

Signed-off-by: Grygorii Strashko <grygorii.strashko@ti.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/ti/cpsw.c

@@ -1340,6 +1340,8 @@ static inline void cpsw_add_dual_emac_def_ale_entries(
 	cpsw_ale_add_ucast(cpsw->ale, priv->mac_addr,
 			   HOST_PORT_NUM, ALE_VLAN |
 			   ALE_SECURE, slave->port_vlan);
+	cpsw_ale_control_set(cpsw->ale, slave_port,
+			     ALE_PORT_DROP_UNKNOWN_VLAN, 1);
 }
 
 static void soft_reset_slave(struct cpsw_slave *slave)