pcmcia vs. MECR on pxa25x/sa1111

After 2.6.34 changes, __pxa2xx_drv_pcmcia_probe() was replaced by
sa1111_pcmcia_add(). That unfortunately means that configure_sockets()
is not called, leading to MECR not being set properly, leading to
strange crashes.

Tested on pxa255+sa1111, I do not have lubbock board nearby. Perhaps
cleaner solution exists?

Signed-off-by: Pavel Machek <pma@sysgo.com>
Signed-off-by: Dominik Brodowski <linux@dominikbrodowski.net>

drivers/pcmcia/pxa2xx_base.c

@@ -215,7 +215,7 @@ pxa2xx_pcmcia_frequency_change(struct soc_pcmcia_socket *skt,
 }
 #endif
 
-static void pxa2xx_configure_sockets(struct device *dev)
+void pxa2xx_configure_sockets(struct device *dev)
 {
 	struct pcmcia_low_level *ops = dev->platform_data;
 	/*

drivers/pcmcia/pxa2xx_base.h

@@ -1,3 +1,4 @@
 int pxa2xx_drv_pcmcia_add_one(struct soc_pcmcia_socket *skt);
 void pxa2xx_drv_pcmcia_ops(struct pcmcia_low_level *ops);
+void pxa2xx_configure_sockets(struct device *dev);
 

drivers/pcmcia/pxa2xx_lubbock.c

@@ -226,6 +226,7 @@ int pcmcia_lubbock_init(struct sa1111_dev *sadev)
 		lubbock_set_misc_wr((1 << 15) | (1 << 14), 0);
 
 		pxa2xx_drv_pcmcia_ops(&lubbock_pcmcia_ops);
+		pxa2xx_configure_sockets(&sadev->dev);
 		ret = sa1111_pcmcia_add(sadev, &lubbock_pcmcia_ops,
 				pxa2xx_drv_pcmcia_add_one);
 	}