scsi: lpfc: Correct MDS diag and nvmet configuration

A recent change added some MDS processing in the lpfc_drain_txq routine
that relies on the fcp_wq being allocated. For nvmet operation the fcp_wq
is not allocated because it can only be an nvme-target.  When the original
MDS support was added LS_MDS_LOOPBACK was defined wrong, (0x16) it should
have been 0x10 (decimal value used for hex setting). This incorrect value
allowed MDS_LOOPBACK to be set simultaneously with LS_NPIV_FAB_SUPPORTED,
causing the driver to crash when it accesses the non-existent fcp_wq.

Correct the bad value setting for LS_MDS_LOOPBACK.

Fixes: 	ae9e28f36a6c  ("lpfc: Add MDS Diagnostic support.")
Cc: <stable@vger.kernel.org> # v4.12+
Signed-off-by: Dick Kennedy <dick.kennedy@broadcom.com>
Signed-off-by: James Smart <james.smart@broadcom.com>
Tested-by: Ewan D. Milne <emilne@redhat.com>
Signed-off-by: Martin K. Petersen <martin.petersen@oracle.com>

drivers/scsi/lpfc/lpfc.h

@@ -672,7 +672,7 @@ struct lpfc_hba {
 #define LS_NPIV_FAB_SUPPORTED 0x2	/* Fabric supports NPIV */
 #define LS_IGNORE_ERATT       0x4	/* intr handler should ignore ERATT */
 #define LS_MDS_LINK_DOWN      0x8	/* MDS Diagnostics Link Down */
-#define LS_MDS_LOOPBACK      0x16	/* MDS Diagnostics Link Up (Loopback) */
+#define LS_MDS_LOOPBACK      0x10	/* MDS Diagnostics Link Up (Loopback) */
 
 	uint32_t hba_flag;	/* hba generic flags */
 #define HBA_ERATT_HANDLED	0x1 /* This flag is set when eratt handled */