spi: cadence: Init HW after reading devicetree attributes

This will make it possible to use the settings specified in the devicetree
to configure the hardware.

Signed-off-by: Paul Cercueil <paul.cercueil@analog.com>
Signed-off-by: Lars-Peter Clausen <lars@metafoo.de>
Reviewed-by: Michal Simek <michal.simek@xilinx.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

drivers/spi/spi-cadence.c

@@ -516,6 +516,17 @@ static int cdns_spi_probe(struct platform_device *pdev)
 		goto clk_dis_apb;
 	}
 
+	ret = of_property_read_u32(pdev->dev.of_node, "num-cs", &num_cs);
+	if (ret < 0)
+		master->num_chipselect = CDNS_SPI_DEFAULT_NUM_CS;
+	else
+		master->num_chipselect = num_cs;
+
+	ret = of_property_read_u32(pdev->dev.of_node, "is-decoded-cs",
+				   &xspi->is_decoded_cs);
+	if (ret < 0)
+		xspi->is_decoded_cs = 0;
+
 	/* SPI controller initializations */
 	cdns_spi_init_hw(xspi);
 
@@ -534,19 +545,6 @@ static int cdns_spi_probe(struct platform_device *pdev)
 		goto remove_master;
 	}
 
-	ret = of_property_read_u32(pdev->dev.of_node, "num-cs", &num_cs);
-
-	if (ret < 0)
-		master->num_chipselect = CDNS_SPI_DEFAULT_NUM_CS;
-	else
-		master->num_chipselect = num_cs;
-
-	ret = of_property_read_u32(pdev->dev.of_node, "is-decoded-cs",
-				   &xspi->is_decoded_cs);
-
-	if (ret < 0)
-		xspi->is_decoded_cs = 0;
-
 	master->prepare_transfer_hardware = cdns_prepare_transfer_hardware;
 	master->prepare_message = cdns_prepare_message;
 	master->transfer_one = cdns_transfer_one;