USB: oti6858: fix abuse of interface data

Fix abuse of interface data which was used to signal device disconnect.

Note that neither tiocmset or tiocmget need to check for disconnect as
they do not access the device.

Signed-off-by: Johan Hovold <jhovold@gmail.com>
Signed-off-by: Greg Kroah-Hartman <gregkh@linuxfoundation.org>

drivers/usb/serial/oti6858.c

@@ -633,9 +633,6 @@ static int oti6858_tiocmset(struct tty_struct *tty,
 	dbg("%s(port = %d, set = 0x%08x, clear = 0x%08x)",
 				__func__, port->number, set, clear);
 
-	if (!usb_get_intfdata(port->serial->interface))
-		return -ENODEV;
-
 	/* FIXME: check if this is correct (active high/low) */
 	spin_lock_irqsave(&priv->lock, flags);
 	control = priv->pending_setup.control;
@@ -665,9 +662,6 @@ static int oti6858_tiocmget(struct tty_struct *tty)
 
 	dbg("%s(port = %d)", __func__, port->number);
 
-	if (!usb_get_intfdata(port->serial->interface))
-		return -ENODEV;
-
 	spin_lock_irqsave(&priv->lock, flags);
 	pin_state = priv->status.pin_state & PIN_MASK;
 	spin_unlock_irqrestore(&priv->lock, flags);