mmc: mmci: Add Qcom datactrl register variant

Instance of this IP on Qualcomm's SOCs has bit different layout for datactrl
register. Bit position datactrl[16:4] hold the true block size instead of power
of 2.

Signed-off-by: Srinivas Kandagatla <srinivas.kandagatla@linaro.org>
Reviewed-by: Linus Walleij <linus.walleij@linaro.org>
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>

drivers/mmc/host/mmci.c

@@ -60,6 +60,8 @@ static unsigned int fmax = 515633;
  * @sdio: variant supports SDIO
  * @st_clkdiv: true if using a ST-specific clock divider algorithm
  * @blksz_datactrl16: true if Block size is at b16..b30 position in datactrl register
+ * @blksz_datactrl4: true if Block size is at b4..b16 position in datactrl
+ *		     register
  * @pwrreg_powerup: power up value for MMCIPOWER register
  * @signal_direction: input/out direction of bus signals can be indicated
  * @pwrreg_clkgate: MMCIPOWER register must be used to gate the clock
@@ -75,6 +77,7 @@ struct variant_data {
 	bool			sdio;
 	bool			st_clkdiv;
 	bool			blksz_datactrl16;
+	bool			blksz_datactrl4;
 	u32			pwrreg_powerup;
 	bool			signal_direction;
 	bool			pwrreg_clkgate;
@@ -732,6 +735,8 @@ static void mmci_start_data(struct mmci_host *host, struct mmc_data *data)
 
 	if (variant->blksz_datactrl16)
 		datactrl = MCI_DPSM_ENABLE | (data->blksz << 16);
+	else if (variant->blksz_datactrl4)
+		datactrl = MCI_DPSM_ENABLE | (data->blksz << 4);
 	else
 		datactrl = MCI_DPSM_ENABLE | blksz_bits << 4;