gpio: altera: Use handle_level_irq when configured as a level_high

When a threaded irq handler is chained attached to one of the gpio
pins when configure for level irq the altera_gpio_irq_leveL_high_handler
does not mask the interrupt while being handled by the chained irq.
This resulting in the threaded irq not getting enough cycles to complete
quickly enough before the irq was disabled as faulty. handle_level_irq
should be used in this situation instead of handle_simple_irq.

In gpiochip_irqchip_add set default handler to handle_bad_irq as
per Documentation/gpio/driver.txt. Then set the correct handler in
the set_type callback.

Signed-off-by: Phil Reid <preid@electromag.com.au>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

drivers/gpio/gpio-altera.c

@@ -90,21 +90,18 @@ static int altera_gpio_irq_set_type(struct irq_data *d,
 
 	altera_gc = gpiochip_get_data(irq_data_get_irq_chip_data(d));
 
-	if (type == IRQ_TYPE_NONE)
+	if (type == IRQ_TYPE_NONE) {
+		irq_set_handler_locked(d, handle_bad_irq);
 		return 0;
-	if (type == IRQ_TYPE_LEVEL_HIGH &&
-		altera_gc->interrupt_trigger == IRQ_TYPE_LEVEL_HIGH)
-		return 0;
-	if (type == IRQ_TYPE_EDGE_RISING &&
-		altera_gc->interrupt_trigger == IRQ_TYPE_EDGE_RISING)
-		return 0;
-	if (type == IRQ_TYPE_EDGE_FALLING &&
-		altera_gc->interrupt_trigger == IRQ_TYPE_EDGE_FALLING)
-		return 0;
-	if (type == IRQ_TYPE_EDGE_BOTH &&
-		altera_gc->interrupt_trigger == IRQ_TYPE_EDGE_BOTH)
+	}
+	if (type == altera_gc->interrupt_trigger) {
+		if (type == IRQ_TYPE_LEVEL_HIGH)
+			irq_set_handler_locked(d, handle_level_irq);
+		else
+			irq_set_handler_locked(d, handle_simple_irq);
 		return 0;
-
+	}
+	irq_set_handler_locked(d, handle_bad_irq);
 	return -EINVAL;
 }
 
@@ -230,7 +227,6 @@ static void altera_gpio_irq_edge_handler(struct irq_desc *desc)
 	chained_irq_exit(chip, desc);
 }
 
-
 static void altera_gpio_irq_leveL_high_handler(struct irq_desc *desc)
 {
 	struct altera_gpio_chip *altera_gc;
@@ -310,7 +306,7 @@ static int altera_gpio_probe(struct platform_device *pdev)
 	altera_gc->interrupt_trigger = reg;
 
 	ret = gpiochip_irqchip_add(&altera_gc->mmchip.gc, &altera_irq_chip, 0,
-		handle_simple_irq, IRQ_TYPE_NONE);
+		handle_bad_irq, IRQ_TYPE_NONE);
 
 	if (ret) {
 		dev_err(&pdev->dev, "could not add irqchip\n");