PCI: Preserve BIOS PCI_COMMAND_SERR and PCI_COMMAND_PARITY settings

Do not clear PCI_COMMAND_SERR or PCI_COMMAND_PARITY based on _HPP.  The
spec (ACPI rev 5.0, sec 6.2.7) says that when "Enable SERR" is set to 1,
we should enable SERR in the command register.  It says nothing about
*disabling* SERR or PERR; in fact, the example in 6.2.7.1 says we should
leave PERR alone unless "Enable PERR" is 1.

For hot-added devices, this probably doesn't matter because they power up
with these bits cleared.  But in addition to hot-plugged devices, the spec
allows the platform to use _HPP for "configuration of PCI devices not
configured by the BIOS at system boot," and it may make a difference for
devices present at boot.

This change means that if BIOS enables SERR or PERR on a device, and it
supplies _HPP or _HPX with the SERR or PERR bits *cleared*, we will now
leave SERR or PERR reporting enabled on that device instead of disabling it
as we previously did.

See also 40abb96c51bb ("pciehp: Fix programming hotplug parameters"), where
this code was first added.

Signed-off-by: Bjorn Helgaas <bhelgaas@google.com>
Acked-by: Yinghai Lu <yinghai@kernel.org>

drivers/pci/probe.c

@@ -1264,12 +1264,8 @@ static void program_hpp_type0(struct pci_dev *dev, struct hpp_type0 *hpp)
 	pci_read_config_word(dev, PCI_COMMAND, &pci_cmd);
 	if (hpp->enable_serr)
 		pci_cmd |= PCI_COMMAND_SERR;
-	else
-		pci_cmd &= ~PCI_COMMAND_SERR;
 	if (hpp->enable_perr)
 		pci_cmd |= PCI_COMMAND_PARITY;
-	else
-		pci_cmd &= ~PCI_COMMAND_PARITY;
 	pci_write_config_word(dev, PCI_COMMAND, pci_cmd);
 
 	/* Program bridge control value */
@@ -1279,12 +1275,8 @@ static void program_hpp_type0(struct pci_dev *dev, struct hpp_type0 *hpp)
 		pci_read_config_word(dev, PCI_BRIDGE_CONTROL, &pci_bctl);
 		if (hpp->enable_serr)
 			pci_bctl |= PCI_BRIDGE_CTL_SERR;
-		else
-			pci_bctl &= ~PCI_BRIDGE_CTL_SERR;
 		if (hpp->enable_perr)
 			pci_bctl |= PCI_BRIDGE_CTL_PARITY;
-		else
-			pci_bctl &= ~PCI_BRIDGE_CTL_PARITY;
 		pci_write_config_word(dev, PCI_BRIDGE_CONTROL, pci_bctl);
 	}
 }