Merge tag 'davinci-for-v4.10/dt-4' of git://git.kernel.org/pub/scm/linux/kernel/git/nsekhar/linux-davinci into next/dt

- Add device tree nodes for pin pull-up/pull-down
bias control on DA850.

- Enable high speed support on DA850 MMC/SD

* tag 'davinci-for-v4.10/dt-4' of git://git.kernel.org/pub/scm/linux/kernel/git/nsekhar/linux-davinci:
  ARM: dts: da850: enable high speed for mmc
  ARM: dts: da850: Add node for pullup/pulldown pinconf

Signed-off-by: Olof Johansson <olof@lixom.net>

arch/arm/boot/dts/da850.dtsi

@@ -317,6 +317,8 @@
 		mmc0: mmc@40000 {
 			compatible = "ti,da830-mmc";
 			reg = <0x40000 0x1000>;
+			cap-sd-highspeed;
+			cap-mmc-highspeed;
 			interrupts = <16>;
 			dmas = <&edma0 16 0>, <&edma0 17 0>;
 			dma-names = "rx", "tx";
@@ -325,6 +327,8 @@
 		mmc1: mmc@21b000 {
 			compatible = "ti,da830-mmc";
 			reg = <0x21b000 0x1000>;
+			cap-sd-highspeed;
+			cap-mmc-highspeed;
 			interrupts = <72>;
 			dmas = <&edma1 28 0>, <&edma1 29 0>;
 			dma-names = "rx", "tx";
@@ -435,6 +439,11 @@
 			ti,davinci-gpio-unbanked = <0>;
 			status = "disabled";
 		};
+		pinconf: pin-controller@22c00c {
+			compatible = "ti,da850-pupd";
+			reg = <0x22c00c 0x8>;
+			status = "disabled";
+		};
 
 		mcasp0: mcasp@100000 {
 			compatible = "ti,da830-mcasp-audio";