mmc: sdhci-s3c: Check if clk_set_rate() succeeds

It is possible that we may fail to set the clock rate, if we do so then
log the failure and don't bother reprogramming the IP.

Signed-off-by: Mark Brown <broonie@linaro.org>
Acked-by: Jaehoon Chung <jh80.chung@samsung.com>
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>

drivers/mmc/host/sdhci-s3c.c

@@ -300,6 +300,7 @@ static void sdhci_cmu_set_clock(struct sdhci_host *host, unsigned int clock)
 	struct device *dev = &ourhost->pdev->dev;
 	unsigned long timeout;
 	u16 clk = 0;
+	int ret;
 
 	host->mmc->actual_clock = 0;
 
@@ -311,7 +312,12 @@ static void sdhci_cmu_set_clock(struct sdhci_host *host, unsigned int clock)
 
 	sdhci_s3c_set_clock(host, clock);
 
-	clk_set_rate(ourhost->clk_bus[ourhost->cur_clk], clock);
+	ret = clk_set_rate(ourhost->clk_bus[ourhost->cur_clk], clock);
+	if (ret != 0) {
+		dev_err(dev, "%s: failed to set clock rate %uHz\n",
+			mmc_hostname(host->mmc), clock);
+		return;
+	}
 
 	clk = SDHCI_CLOCK_INT_EN;
 	sdhci_writew(host, clk, SDHCI_CLOCK_CONTROL);