ice: Align ice_reset_req enum values to hardware reset values

Currently the ice_reset_req enum values have to be translated into
a different set of values that the hardware understands for the same
reset types. Avoid this translation by aligning ice_reset_req enum
values to the ones that the hardware understands.

Also add and else if block to check for ICE_RESET_EMPR and put a dev_dbg
message in the else case.

Signed-off-by: Brett Creeley <brett.creeley@intel.com>
Signed-off-by: Anirudh Venkataramanan <anirudh.venkataramanan@intel.com>
Tested-by: Andrew Bowers <andrewx.bowers@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>

drivers/net/ethernet/intel/ice/ice_main.c

@@ -1241,8 +1241,11 @@ static irqreturn_t ice_misc_intr(int __always_unused irq, void *data)
 			pf->corer_count++;
 		else if (reset == ICE_RESET_GLOBR)
 			pf->globr_count++;
-		else
+		else if (reset == ICE_RESET_EMPR)
 			pf->empr_count++;
+		else
+			dev_dbg(&pf->pdev->dev, "Invalid reset type %d\n",
+				reset);
 
 		/* If a reset cycle isn't already in progress, we set a bit in
 		 * pf->state so that the service task can start a reset/rebuild.

drivers/net/ethernet/intel/ice/ice_type.h

@@ -150,12 +150,18 @@ struct ice_mac_info {
 	u8 perm_addr[ETH_ALEN];
 };
 
-/* Various RESET request, These are not tied with HW reset types */
+/* Reset types used to determine which kind of reset was requested. These
+ * defines match what the RESET_TYPE field of the GLGEN_RSTAT register.
+ * ICE_RESET_PFR does not match any RESET_TYPE field in the GLGEN_RSTAT register
+ * because its reset source is different than the other types listed.
+ */
 enum ice_reset_req {
+	ICE_RESET_POR	= 0,
 	ICE_RESET_INVAL	= 0,
-	ICE_RESET_PFR	= 1,
-	ICE_RESET_CORER	= 2,
-	ICE_RESET_GLOBR	= 3,
+	ICE_RESET_CORER	= 1,
+	ICE_RESET_GLOBR	= 2,
+	ICE_RESET_EMPR	= 3,
+	ICE_RESET_PFR	= 4,
 };
 
 /* Bus parameters */