media/bt8xx: Remove old powerpc cruft

The powerpc arch code enables PCI_COMMAND_MEMORY (and has done so for
more than 10 years at least !) on pci_enable_device() and the hackery
on the MMIO accessor is useless as well, our writel does everything
this driver should need.

Signed-off-by: Benjamin Herrenschmidt <benh@kernel.crashing.org>

drivers/media/pci/bt8xx/bt878.c

@@ -416,9 +416,6 @@ static int bt878_probe(struct pci_dev *dev, const struct pci_device_id *pci_id)
 	int result = 0;
 	unsigned char lat;
 	struct bt878 *bt;
-#if defined(__powerpc__)
-	unsigned int cmd;
-#endif
 	unsigned int cardid;
 
 	printk(KERN_INFO "bt878: Bt878 AUDIO function found (%d).\n",
@@ -461,15 +458,6 @@ static int bt878_probe(struct pci_dev *dev, const struct pci_device_id *pci_id)
 	printk("irq: %d, latency: %d, memory: 0x%lx\n",
 	       bt->irq, lat, bt->bt878_adr);
 
-
-#if defined(__powerpc__)
-	/* on OpenFirmware machines (PowerMac at least), PCI memory cycle */
-	/* response on cards with no firmware is not enabled by OF */
-	pci_read_config_dword(dev, PCI_COMMAND, &cmd);
-	cmd = (cmd | PCI_COMMAND_MEMORY);
-	pci_write_config_dword(dev, PCI_COMMAND, cmd);
-#endif
-
 #ifdef __sparc__
 	bt->bt878_mem = (unsigned char *) bt->bt878_adr;
 #else

drivers/media/pci/bt8xx/bt878.h

@@ -142,18 +142,7 @@ void bt878_start(struct bt878 *bt, u32 controlreg, u32 op_sync_orin,
 		u32 irq_err_ignore);
 void bt878_stop(struct bt878 *bt);
 
-#if defined(__powerpc__)	/* big-endian */
-static inline void io_st_le32(volatile unsigned __iomem *addr, unsigned val)
-{
-	st_le32(addr, val);
-	eieio();
-}
-
-#define bmtwrite(dat,adr)  io_st_le32((adr),(dat))
-#define bmtread(adr)       ld_le32((adr))
-#else
 #define bmtwrite(dat,adr)  writel((dat), (adr))
 #define bmtread(adr)       readl(adr)
-#endif
 
 #endif