qla2xxx: Reset reserved field in firmware options to 0

During NVRAM initialization in target mode, reset reserved
fields in firmware options to Zero (BIT 15)

Signed-off-by: Himanshu Madhani <himanshu.madhani@cavium.com>
Signed-off-by: Giridhar Malavali <giridhar.malavali@cavium.com>
Reviewed-by: Christoph Hellwig <hch@lst.de>
Signed-off-by: Bart Van Assche <bart.vanassche@sandisk.com>

drivers/scsi/qla2xxx/qla_target.c

@@ -6542,6 +6542,13 @@ qlt_24xx_config_nvram_stage1(struct scsi_qla_host *vha, struct nvram_24xx *nv)
 
 		/* Disable Full Login after LIP */
 		nv->host_p &= cpu_to_le32(~BIT_10);
+
+		/*
+		 * clear BIT 15 explicitly as we have seen at least
+		 * a couple of instances where this was set and this
+		 * was causing the firmware to not be initialized.
+		 */
+		nv->firmware_options_1 &= cpu_to_le32(~BIT_15);
 		/* Enable target PRLI control */
 		nv->firmware_options_2 |= cpu_to_le32(BIT_14);
 	} else {
@@ -6626,11 +6633,17 @@ qlt_81xx_config_nvram_stage1(struct scsi_qla_host *vha, struct nvram_81xx *nv)
 		/* Disable ini mode, if requested */
 		if (!qla_ini_mode_enabled(vha))
 			nv->firmware_options_1 |= cpu_to_le32(BIT_5);
-
 		/* Disable Full Login after LIP */
 		nv->firmware_options_1 &= cpu_to_le32(~BIT_13);
 		/* Enable initial LIP */
 		nv->firmware_options_1 &= cpu_to_le32(~BIT_9);
+		/*
+		 * clear BIT 15 explicitly as we have seen at
+		 * least a couple of instances where this was set
+		 * and this was causing the firmware to not be
+		 * initialized.
+		 */
+		nv->firmware_options_1 &= cpu_to_le32(~BIT_15);
 		if (ql2xtgt_tape_enable)
 			/* Enable FC tape support */
 			nv->firmware_options_2 |= cpu_to_le32(BIT_12);