bridge: Remove unnecessary vlan_put_tag in br_handle_vlan

br_handle_vlan() pushes HW accelerated vlan tag into skbuff when outgoing
port is the bridge device.
This is unnecessary because __netif_receive_skb_core() can handle skbs
with HW accelerated vlan tag. In current implementation,
__netif_receive_skb_core() needs to extract the vlan tag embedded in skb
data. This could cause low network performance especially when receiving
frames at a high frame rate on the bridge device.

Signed-off-by: Toshiaki Makita <makita.toshiaki@lab.ntt.co.jp>
Acked-by: Vlad Yasevich <vyasevic@redhat.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

net/bridge/br_vlan.c

@@ -151,27 +151,6 @@ struct sk_buff *br_handle_vlan(struct net_bridge *br,
 	br_vlan_get_tag(skb, &vid);
 	if (test_bit(vid, pv->untagged_bitmap))
 		skb = br_vlan_untag(skb);
-	else {
-		/* Egress policy says "send tagged".  If output device
-		 * is the  bridge, we need to add the VLAN header
-		 * ourselves since we'll be going through the RX path.
-		 * Sending to ports puts the frame on the TX path and
-		 * we let dev_hard_start_xmit() add the header.
-		 */
-		if (skb->protocol != htons(ETH_P_8021Q) &&
-		    pv->port_idx == 0) {
-			/* vlan_put_tag expects skb->data to point to
-			 * mac header.
-			 */
-			skb_push(skb, ETH_HLEN);
-			skb = __vlan_put_tag(skb, skb->vlan_proto, skb->vlan_tci);
-			if (!skb)
-				goto out;
-			/* put skb->data back to where it was */
-			skb_pull(skb, ETH_HLEN);
-			skb->vlan_tci = 0;
-		}
-	}
 
 out:
 	return skb;