bnx2x: Add missing bit in default Tx switching

Commit c14db2025 "bnx2x: Correct default Tx switching behaviour" supposedly
changed the default Tx switching behaviour, but was missing the fastpath change
required for FW to pass packets from PFs to VFs.

Signed-off-by: Yuval Mintz <yuvalmin@broadcom.com>
Signed-off-by: Ariel Elior <ariele@broadcom.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/broadcom/bnx2x/bnx2x_cmn.c

@@ -3875,7 +3875,9 @@ netdev_tx_t bnx2x_start_xmit(struct sk_buff *skb, struct net_device *dev)
 						     xmit_type);
 		}
 
-		/* Add the macs to the parsing BD this is a vf */
+		/* Add the macs to the parsing BD if this is a vf or if
+		 * Tx Switching is enabled.
+		 */
 		if (IS_VF(bp)) {
 			/* override GRE parameters in BD */
 			bnx2x_set_fw_mac_addr(&pbd_e2->data.mac_addr.src_hi,
@@ -3883,6 +3885,11 @@ netdev_tx_t bnx2x_start_xmit(struct sk_buff *skb, struct net_device *dev)
 					      &pbd_e2->data.mac_addr.src_lo,
 					      eth->h_source);
 
+			bnx2x_set_fw_mac_addr(&pbd_e2->data.mac_addr.dst_hi,
+					      &pbd_e2->data.mac_addr.dst_mid,
+					      &pbd_e2->data.mac_addr.dst_lo,
+					      eth->h_dest);
+		} else if (bp->flags & TX_SWITCHING) {
 			bnx2x_set_fw_mac_addr(&pbd_e2->data.mac_addr.dst_hi,
 					      &pbd_e2->data.mac_addr.dst_mid,
 					      &pbd_e2->data.mac_addr.dst_lo,