powerpc/fsl_rio: apply changes for RIO spec rev 3

 - Remove check for parallel PHY

 - Set LP-Serial Register Map type

[akpm@linux-foundation.org: fix build]
[alexandre.bounine@idt.com: fix build fix]
 Link: http://lkml.kernel.org/r/20160802184932.2755-1-alexandre.bounine@idt.com
Link: http://lkml.kernel.org/r/1469125134-16523-13-git-send-email-alexandre.bounine@idt.com
Signed-off-by: Alexandre Bounine <alexandre.bounine@idt.com>
Cc: Matt Porter <mporter@kernel.crashing.org>
Cc: Benjamin Herrenschmidt <benh@kernel.crashing.org>
Cc: Michael Ellerman <mpe@ellerman.id.au>
Cc: Andre van Herk <andre.van.herk@prodrive-technologies.com>
Cc: Barry Wood <barry.wood@idt.com>
Signed-off-by: Andrew Morton <akpm@linux-foundation.org>
Signed-off-by: Linus Torvalds <torvalds@linux-foundation.org>

arch/powerpc/sysdev/fsl_rio.c

@@ -643,19 +643,11 @@ int fsl_rio_setup(struct platform_device *dev)
 		port->ops = ops;
 		port->priv = priv;
 		port->phys_efptr = 0x100;
+		port->phys_rmap = 1;
 		priv->regs_win = rio_regs_win;
 
-		/* Probe the master port phy type */
 		ccsr = in_be32(priv->regs_win + RIO_CCSR + i*0x20);
-		port->phy_type = (ccsr & 1) ? RIO_PHY_SERIAL : RIO_PHY_PARALLEL;
-		if (port->phy_type == RIO_PHY_PARALLEL) {
-			dev_err(&dev->dev, "RIO: Parallel PHY type, unsupported port type!\n");
-			release_resource(&port->iores);
-			kfree(priv);
-			kfree(port);
-			continue;
-		}
-		dev_info(&dev->dev, "RapidIO PHY type: Serial\n");
+
 		/* Checking the port training status */
 		if (in_be32((priv->regs_win + RIO_ESCSR + i*0x20)) & 1) {
 			dev_err(&dev->dev, "Port %d is not ready. "
@@ -705,11 +697,9 @@ int fsl_rio_setup(struct platform_device *dev)
 			((i == 0) ? RIO_INB_ATMU_REGS_PORT1_OFFSET :
 			RIO_INB_ATMU_REGS_PORT2_OFFSET));
 
-
-		/* Set to receive any dist ID for serial RapidIO controller. */
-		if (port->phy_type == RIO_PHY_SERIAL)
-			out_be32((priv->regs_win
-				+ RIO_ISR_AACR + i*0x80), RIO_ISR_AACR_AA);
+		/* Set to receive packets with any dest ID */
+		out_be32((priv->regs_win + RIO_ISR_AACR + i*0x80),
+			 RIO_ISR_AACR_AA);
 
 		/* Configure maintenance transaction window */
 		out_be32(&priv->maint_atmu_regs->rowbar,