mfd: twl6040: Correct HPPLL configuration for 19.2 and 38.4 MHz mclk

When the MCLK is 19.2 or 38.4 MHz the HPPLL need to be enabled and can be
put in bypass mode.
This will fix HPPLL use on boards with 19.2MHz mclk.

Signed-off-by: Peter Ujfalusi <peter.ujfalusi@ti.com>
Signed-off-by: Lee Jones <lee.jones@linaro.org>

drivers/mfd/twl6040.c

@@ -441,12 +441,9 @@ int twl6040_set_pll(struct twl6040 *twl6040, int pll_id,
 					    TWL6040_HPLLENA;
 				break;
 			case 19200000:
-				/*
-				* PLL disabled
-				* (enable PLL if MCLK jitter quality
-				*  doesn't meet specification)
-				*/
-				hppllctl |= TWL6040_MCLK_19200KHZ;
+				/* PLL enabled, bypass mode */
+				hppllctl |= TWL6040_MCLK_19200KHZ |
+					    TWL6040_HPLLBP | TWL6040_HPLLENA;
 				break;
 			case 26000000:
 				/* PLL enabled, active mode */
@@ -454,9 +451,9 @@ int twl6040_set_pll(struct twl6040 *twl6040, int pll_id,
 					    TWL6040_HPLLENA;
 				break;
 			case 38400000:
-				/* PLL enabled, active mode */
+				/* PLL enabled, bypass mode */
 				hppllctl |= TWL6040_MCLK_38400KHZ |
-					    TWL6040_HPLLENA;
+					    TWL6040_HPLLBP | TWL6040_HPLLENA;
 				break;
 			default:
 				dev_err(twl6040->dev,