mmc: host: omap_hsmmc: Add CMD23 capability to omap_hsmmc driver

omap_hsmmc driver always relied on CMD12 to stop transmission.
However if CMD12 is not issued at the correct timing, the card will
indicate a out of range error. With certain cards in some of the
DRA7 based boards, -EIO error is observed. By Adding CMD23 capability,
the MMC core will send MMC_SET_BLOCK_COUNT command before
MMC_READ_MULTIPLE_BLOCK/MMC_WRITE_MULTIPLE_BLOCK commands.

commit a04e6bae9e6f12 ("mmc: core: check also R1 response for
stop commands") exposed this bug in omap_hsmmc driver.

Signed-off-by: Kishon Vijay Abraham I <kishon@ti.com>
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>

drivers/mmc/host/omap_hsmmc.c

@@ -2086,7 +2086,7 @@ static int omap_hsmmc_probe(struct platform_device *pdev)
 	mmc->max_seg_size = mmc->max_req_size;
 
 	mmc->caps |= MMC_CAP_MMC_HIGHSPEED | MMC_CAP_SD_HIGHSPEED |
-		     MMC_CAP_WAIT_WHILE_BUSY | MMC_CAP_ERASE;
+		     MMC_CAP_WAIT_WHILE_BUSY | MMC_CAP_ERASE | MMC_CAP_CMD23;
 
 	mmc->caps |= mmc_pdata(host)->caps;
 	if (mmc->caps & MMC_CAP_8_BIT_DATA)