pasemi_mac: Replace LRO with GRO

GRO is simpler to use than the old inet_lro library, and is compatible
with forwarding and bridging configurations.

Compile-tested only.

Signed-off-by: Ben Hutchings <ben@decadent.org.uk>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/pasemi/Kconfig

@@ -5,7 +5,7 @@
 config NET_VENDOR_PASEMI
 	bool "PA Semi devices"
 	default y
-	depends on PPC_PASEMI && PCI && INET
+	depends on PPC_PASEMI && PCI
 	---help---
 	  If you have a network (Ethernet) card belonging to this class, say Y.
 
@@ -18,9 +18,8 @@ if NET_VENDOR_PASEMI
 
 config PASEMI_MAC
 	tristate "PA Semi 1/10Gbit MAC"
-	depends on PPC_PASEMI && PCI && INET
+	depends on PPC_PASEMI && PCI
 	select PHYLIB
-	select INET_LRO
 	---help---
 	  This driver supports the on-chip 1/10Gbit Ethernet controller on
 	  PA Semi's PWRficient line of chips.

drivers/net/ethernet/pasemi/pasemi_mac.c

@@ -30,9 +30,7 @@
 #include <linux/skbuff.h>
 
 #include <linux/ip.h>
-#include <linux/tcp.h>
 #include <net/checksum.h>
-#include <linux/inet_lro.h>
 #include <linux/prefetch.h>
 
 #include <asm/irq.h>
@@ -52,12 +50,9 @@
  *
  * - Multicast support
  * - Large MTU support
- * - SW LRO
  * - Multiqueue RX/TX
  */
 
-#define LRO_MAX_AGGR 64
-
 #define PE_MIN_MTU	64
 #define PE_MAX_MTU	9000
 #define PE_DEF_MTU	ETH_DATA_LEN
@@ -257,37 +252,6 @@ static int pasemi_mac_set_mac_addr(struct net_device *dev, void *p)
 	return 0;
 }
 
-static int get_skb_hdr(struct sk_buff *skb, void **iphdr,
-		       void **tcph, u64 *hdr_flags, void *data)
-{
-	u64 macrx = (u64) data;
-	unsigned int ip_len;
-	struct iphdr *iph;
-
-	/* IPv4 header checksum failed */
-	if ((macrx & XCT_MACRX_HTY_M) != XCT_MACRX_HTY_IPV4_OK)
-		return -1;
-
-	/* non tcp packet */
-	skb_reset_network_header(skb);
-	iph = ip_hdr(skb);
-	if (iph->protocol != IPPROTO_TCP)
-		return -1;
-
-	ip_len = ip_hdrlen(skb);
-	skb_set_transport_header(skb, ip_len);
-	*tcph = tcp_hdr(skb);
-
-	/* check if ip header and tcp header are complete */
-	if (ntohs(iph->tot_len) < ip_len + tcp_hdrlen(skb))
-		return -1;
-
-	*hdr_flags = LRO_IPV4 | LRO_TCP;
-	*iphdr = iph;
-
-	return 0;
-}
-
 static int pasemi_mac_unmap_tx_skb(struct pasemi_mac *mac,
 				    const int nfrags,
 				    struct sk_buff *skb,
@@ -817,7 +781,7 @@ static int pasemi_mac_clean_rx(struct pasemi_mac_rxring *rx,
 		skb_put(skb, len-4);
 
 		skb->protocol = eth_type_trans(skb, mac->netdev);
-		lro_receive_skb(&mac->lro_mgr, skb, (void *)macrx);
+		napi_gro_receive(&mac->napi, skb);
 
 next:
 		RX_DESC(rx, n) = 0;
@@ -839,8 +803,6 @@ next:
 
 	rx_ring(mac)->next_to_clean = n;
 
-	lro_flush_all(&mac->lro_mgr);
-
 	/* Increase is in number of 16-byte entries, and since each descriptor
 	 * with an 8BRES takes up 3x8 bytes (padded to 4x8), increase with
 	 * count*2.
@@ -1754,16 +1716,6 @@ pasemi_mac_probe(struct pci_dev *pdev, const struct pci_device_id *ent)
 	dev->features = NETIF_F_IP_CSUM | NETIF_F_LLTX | NETIF_F_SG |
 			NETIF_F_HIGHDMA | NETIF_F_GSO;
 
-	mac->lro_mgr.max_aggr = LRO_MAX_AGGR;
-	mac->lro_mgr.max_desc = MAX_LRO_DESCRIPTORS;
-	mac->lro_mgr.lro_arr = mac->lro_desc;
-	mac->lro_mgr.get_skb_header = get_skb_hdr;
-	mac->lro_mgr.features = LRO_F_NAPI | LRO_F_EXTRACT_VLAN_ID;
-	mac->lro_mgr.dev = mac->netdev;
-	mac->lro_mgr.ip_summed = CHECKSUM_UNNECESSARY;
-	mac->lro_mgr.ip_summed_aggr = CHECKSUM_UNNECESSARY;
-
-
 	mac->dma_pdev = pci_get_device(PCI_VENDOR_ID_PASEMI, 0xa007, NULL);
 	if (!mac->dma_pdev) {
 		dev_err(&mac->pdev->dev, "Can't find DMA Controller\n");

drivers/net/ethernet/pasemi/pasemi_mac.h

@@ -31,7 +31,6 @@
 #define CS_RING_SIZE (TX_RING_SIZE*2)
 
 
-#define MAX_LRO_DESCRIPTORS 8
 #define MAX_CS	2
 
 struct pasemi_mac_txring {
@@ -84,10 +83,7 @@ struct pasemi_mac {
 
 	u8		mac_addr[ETH_ALEN];
 
-	struct net_lro_mgr	lro_mgr;
-	struct net_lro_desc	lro_desc[MAX_LRO_DESCRIPTORS];
 	struct timer_list	rxtimer;
-	unsigned int		lro_max_aggr;
 
 	struct pasemi_mac_txring *tx;
 	struct pasemi_mac_rxring *rx;

drivers/net/ethernet/pasemi/pasemi_mac_ethtool.c

@@ -20,7 +20,6 @@
 #include <linux/netdevice.h>
 #include <linux/ethtool.h>
 #include <linux/pci.h>
-#include <linux/inet_lro.h>
 
 #include <asm/pasemi_dma.h>
 #include "pasemi_mac.h"