dt-bindings: power: supply: New bindings for ltc3651-charger

This adds the devicetree bindings documentation for the LTC3651 battery charger.

Signed-off-by: Mike Looijmans <mike.looijmans@topic.nl>
Acked-by: Rob Herring <robh@kernel.org>
Signed-off-by: Sebastian Reichel <sebastian.reichel@collabora.co.uk>

Documentation/devicetree/bindings/power/supply/ltc3651-charger.txt

@@ -0,0 +1,27 @@
+ltc3651-charger
+
+Required properties:
+ - compatible: "lltc,ltc3651-charger"
+ - lltc,acpr-gpios: Connect to ACPR output. See remark below.
+
+Optional properties:
+ - lltc,fault-gpios: Connect to FAULT output. See remark below.
+ - lltc,chrg-gpios: Connect to CHRG output. See remark below.
+
+The ltc3651 outputs are open-drain type and active low. The driver assumes the
+GPIO reports "active" when the output is asserted, so if the pins have been
+connected directly, the GPIO flags should be set to active low also.
+
+The driver will attempt to aquire interrupts for all GPIOs to detect changes in
+line state. If the system is not capabale of providing interrupts, the driver
+cannot report changes and userspace will need to periodically read the sysfs
+attributes to detect changes.
+
+Example:
+
+	charger: battery-charger {
+		compatible = "lltc,ltc3651-charger";
+		lltc,acpr-gpios = <&gpio0 68 GPIO_ACTIVE_LOW>;
+		lltc,fault-gpios = <&gpio0 64 GPIO_ACTIVE_LOW>;
+		lltc,chrg-gpios = <&gpio0 63 GPIO_ACTIVE_LOW>;
+	};