[SCSI] qla2xxx: Correct issue where vport-state was not updated during an ISP_ABORT_NEEDED requst.

While running IO simultaneously through physical port and virtual
port, if user changes Data Rate (from scli utility), IO through
virtual port fails.  It failed because the vport had not received
the ISP_ABORT_NEEDED notification.

Signed-Off-by: Seokmann Ju <seokmann.ju@qlogic.com>
Signed-off-by: Andrew Vasquez <andrew.vasquez@qlogic.com>
Signed-off-by: James Bottomley <James.Bottomley@HansenPartnership.com>

drivers/scsi/qla2xxx/qla_os.c

@@ -2227,6 +2227,9 @@ qla2x00_do_dpc(void *data)
 	fc_port_t	*fcport;
 	uint8_t		status;
 	uint16_t	next_loopid;
+	struct scsi_qla_host *vha;
+	int             i;
+
 
 	ha = (scsi_qla_host_t *)data;
 
@@ -2269,6 +2272,18 @@ qla2x00_do_dpc(void *data)
 				}
 				clear_bit(ABORT_ISP_ACTIVE, &ha->dpc_flags);
 			}
+
+			for_each_mapped_vp_idx(ha, i) {
+				list_for_each_entry(vha, &ha->vp_list,
+				    vp_list) {
+					if (i == vha->vp_idx) {
+						set_bit(ISP_ABORT_NEEDED,
+						    &vha->dpc_flags);
+						break;
+					}
+				}
+			}
+
 			DEBUG(printk("scsi(%ld): dpc: qla2x00_abort_isp end\n",
 			    ha->host_no));
 		}