iwlwifi: mvm: wait for d0i3 exit in some more ampdu actions

Some ampdu actions change queues by direct target access.

Since the bus is disabled in d0i3, make sure to exit d0i3
before handling these actions.

Signed-off-by: Eliad Peller <eliadx.peller@intel.com>
Reviewed-by: Arik Nemtsov <arik@wizery.com>
Signed-off-by: Emmanuel Grumbach <emmanuel.grumbach@intel.com>

drivers/net/wireless/iwlwifi/mvm/mac80211.c

@@ -539,13 +539,22 @@ static int iwl_mvm_mac_ampdu_action(struct ieee80211_hw *hw,
 		return -EACCES;
 
 	/* return from D0i3 before starting a new Tx aggregation */
-	if (action == IEEE80211_AMPDU_TX_START) {
+	switch (action) {
+	case IEEE80211_AMPDU_TX_START:
+	case IEEE80211_AMPDU_TX_STOP_CONT:
+	case IEEE80211_AMPDU_TX_STOP_FLUSH:
+	case IEEE80211_AMPDU_TX_STOP_FLUSH_CONT:
+	case IEEE80211_AMPDU_TX_OPERATIONAL:
 		iwl_mvm_ref(mvm, IWL_MVM_REF_TX_AGG);
 		tx_agg_ref = true;
 
 		/*
-		 * wait synchronously until D0i3 exit to get the correct
-		 * sequence number for the tid
+		 * for tx start, wait synchronously until D0i3 exit to
+		 * get the correct sequence number for the tid.
+		 * additionally, some other ampdu actions use direct
+		 * target access, which is not handled automatically
+		 * by the trans layer (unlike commands), so wait for
+		 * d0i3 exit in these cases as well.
 		 */
 		if (!wait_event_timeout(mvm->d0i3_exit_waitq,
 			  !test_bit(IWL_MVM_STATUS_IN_D0I3, &mvm->status), HZ)) {
@@ -553,6 +562,9 @@ static int iwl_mvm_mac_ampdu_action(struct ieee80211_hw *hw,
 			iwl_mvm_unref(mvm, IWL_MVM_REF_TX_AGG);
 			return -EIO;
 		}
+		break;
+	default:
+		break;
 	}
 
 	mutex_lock(&mvm->mutex);