|
@@ -0,0 +1,49 @@
|
|
|
|
+The Imagination Technologies SPDIF Input controller contains the following
|
|
|
|
+controls:
|
|
|
|
+
|
|
|
|
+name='IEC958 Capture Mask',index=0
|
|
|
|
+
|
|
|
|
+This control returns a mask that shows which of the IEC958 status bits
|
|
|
|
+can be read using the 'IEC958 Capture Default' control.
|
|
|
|
+
|
|
|
|
+name='IEC958 Capture Default',index=0
|
|
|
|
+
|
|
|
|
+This control returns the status bits contained within the SPDIF stream that
|
|
|
|
+is being received. The 'IEC958 Capture Mask' shows which bits can be read
|
|
|
|
+from this control.
|
|
|
|
+
|
|
|
|
+name='SPDIF In Multi Frequency Acquire',index=0
|
|
|
|
+name='SPDIF In Multi Frequency Acquire',index=1
|
|
|
|
+name='SPDIF In Multi Frequency Acquire',index=2
|
|
|
|
+name='SPDIF In Multi Frequency Acquire',index=3
|
|
|
|
+
|
|
|
|
+This control is used to attempt acquisition of up to four different sample
|
|
|
|
+rates. The active rate can be obtained by reading the 'SPDIF In Lock Frequency'
|
|
|
|
+control.
|
|
|
|
+
|
|
|
|
+When the value of this control is set to {0,0,0,0}, the rate given to hw_params
|
|
|
|
+will determine the single rate the block will capture. Else, the rate given to
|
|
|
|
+hw_params will be ignored, and the block will attempt capture for each of the
|
|
|
|
+four sample rates set here.
|
|
|
|
+
|
|
|
|
+If less than four rates are required, the same rate can be specified more than
|
|
|
|
+once
|
|
|
|
+
|
|
|
|
+name='SPDIF In Lock Frequency',index=0
|
|
|
|
+
|
|
|
|
+This control returns the active capture rate, or 0 if a lock has not been
|
|
|
|
+acquired
|
|
|
|
+
|
|
|
|
+name='SPDIF In Lock TRK',index=0
|
|
|
|
+
|
|
|
|
+This control is used to modify the locking/jitter rejection characteristics
|
|
|
|
+of the block. Larger values increase the locking range, but reduce jitter
|
|
|
|
+rejection.
|
|
|
|
+
|
|
|
|
+name='SPDIF In Lock Acquire Threshold',index=0
|
|
|
|
+
|
|
|
|
+This control is used to change the threshold at which a lock is acquired.
|
|
|
|
+
|
|
|
|
+name='SPDIF In Lock Release Threshold',index=0
|
|
|
|
+
|
|
|
|
+This control is used to change the threshold at which a lock is released.
|