|
@@ -1,7 +1,7 @@
|
|
|
Qualcomm MSM8974 TLMM block
|
|
|
|
|
|
Required properties:
|
|
|
-- compatible: "qcom,msm8x74-pinctrl"
|
|
|
+- compatible: "qcom,msm8974-pinctrl"
|
|
|
- reg: Should be the base address and length of the TLMM block.
|
|
|
- interrupts: Should be the parent IRQ of the TLMM block.
|
|
|
- interrupt-controller: Marks the device node as an interrupt controller.
|
|
@@ -42,14 +42,14 @@ Non-empty subnodes must specify the 'pins' property.
|
|
|
Note that not all properties are valid for all pins.
|
|
|
|
|
|
|
|
|
-Valid values for qcom,pins are:
|
|
|
+Valid values for pins are:
|
|
|
gpio0-gpio145
|
|
|
Supports mux, bias and drive-strength
|
|
|
|
|
|
sdc1_clk, sdc1_cmd, sdc1_data, sdc2_clk, sdc2_cmd, sdc2_data
|
|
|
Supports bias and drive-strength
|
|
|
|
|
|
-Valid values for qcom,function are:
|
|
|
+Valid values for function are:
|
|
|
blsp_i2c2, blsp_i2c6, blsp_i2c11, blsp_spi1, blsp_uart2, blsp_uart8, slimbus
|
|
|
|
|
|
(Note that this is not yet the complete list of functions)
|
|
@@ -73,18 +73,18 @@ Example:
|
|
|
|
|
|
uart2_default: uart2_default {
|
|
|
mux {
|
|
|
- qcom,pins = "gpio4", "gpio5";
|
|
|
- qcom,function = "blsp_uart2";
|
|
|
+ pins = "gpio4", "gpio5";
|
|
|
+ function = "blsp_uart2";
|
|
|
};
|
|
|
|
|
|
tx {
|
|
|
- qcom,pins = "gpio4";
|
|
|
+ pins = "gpio4";
|
|
|
drive-strength = <4>;
|
|
|
bias-disable;
|
|
|
};
|
|
|
|
|
|
rx {
|
|
|
- qcom,pins = "gpio5";
|
|
|
+ pins = "gpio5";
|
|
|
drive-strength = <2>;
|
|
|
bias-pull-up;
|
|
|
};
|