ftrace: Calculate the correct dyn_ftrace number to report to the userspace

Now, ftrace only calculate the dyn_ftrace number in the adding
breakpoint loop, not in adding update and finish update loop.

Calculate the correct dyn_ftrace, once ftrace reports the failure message
to the userspace.

Link: http://lkml.kernel.org/r/1442420382-13130-1-git-send-email-mnfhuang@gmail.com

Signed-off-by: Minfei Huang <mnfhuang@gmail.com>
Signed-off-by: Steven Rostedt <rostedt@goodmis.org>

arch/x86/kernel/ftrace.c

@@ -556,6 +556,7 @@ void ftrace_replace_code(int enable)
 	run_sync();
 
 	report = "updating code";
+	count = 0;
 
 	for_ftrace_rec_iter(iter) {
 		rec = ftrace_rec_iter_record(iter);
@@ -563,11 +564,13 @@ void ftrace_replace_code(int enable)
 		ret = add_update(rec, enable);
 		if (ret)
 			goto remove_breakpoints;
+		count++;
 	}
 
 	run_sync();
 
 	report = "removing breakpoints";
+	count = 0;
 
 	for_ftrace_rec_iter(iter) {
 		rec = ftrace_rec_iter_record(iter);
@@ -575,6 +578,7 @@ void ftrace_replace_code(int enable)
 		ret = finish_update(rec, enable);
 		if (ret)
 			goto remove_breakpoints;
+		count++;
 	}
 
 	run_sync();