net: macb: Added PCI wrapper for Platform Driver.

There are hardware PCI implementations of Cadence GEM network
controller. This patch will allow to use such hardware with reuse of
existing Platform Driver.

Signed-off-by: Bartosz Folta <bfolta@cadence.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/cadence/Kconfig

@@ -31,4 +31,13 @@ config MACB
 	  To compile this driver as a module, choose M here: the module
 	  will be called macb.
 
+config MACB_PCI
+	tristate "Cadence PCI MACB/GEM support"
+	depends on MACB && PCI && COMMON_CLK
+	---help---
+	  This is PCI wrapper for MACB driver.
+
+	  To compile this driver as a module, choose M here: the module
+	  will be called macb_pci.
+
 endif # NET_CADENCE

drivers/net/ethernet/cadence/Makefile

@@ -3,3 +3,4 @@
 #
 
 obj-$(CONFIG_MACB) += macb.o
+obj-$(CONFIG_MACB_PCI) += macb_pci.o

drivers/net/ethernet/cadence/macb.c

@@ -404,6 +404,8 @@ static int macb_mii_probe(struct net_device *dev)
 			phy_irq = gpio_to_irq(pdata->phy_irq_pin);
 			phydev->irq = (phy_irq < 0) ? PHY_POLL : phy_irq;
 		}
+	} else {
+		phydev->irq = PHY_POLL;
 	}
 
 	/* attach the mac to the phy */
@@ -482,6 +484,9 @@ static int macb_mii_init(struct macb *bp)
 				goto err_out_unregister_bus;
 		}
 	} else {
+		for (i = 0; i < PHY_MAX_ADDR; i++)
+			bp->mii_bus->irq[i] = PHY_POLL;
+
 		if (pdata)
 			bp->mii_bus->phy_mask = pdata->phy_mask;
 
@@ -2523,16 +2528,24 @@ static int macb_clk_init(struct platform_device *pdev, struct clk **pclk,
 			 struct clk **hclk, struct clk **tx_clk,
 			 struct clk **rx_clk)
 {
+	struct macb_platform_data *pdata;
 	int err;
 
-	*pclk = devm_clk_get(&pdev->dev, "pclk");
+	pdata = dev_get_platdata(&pdev->dev);
+	if (pdata) {
+		*pclk = pdata->pclk;
+		*hclk = pdata->hclk;
+	} else {
+		*pclk = devm_clk_get(&pdev->dev, "pclk");
+		*hclk = devm_clk_get(&pdev->dev, "hclk");
+	}
+
 	if (IS_ERR(*pclk)) {
 		err = PTR_ERR(*pclk);
 		dev_err(&pdev->dev, "failed to get macb_clk (%u)\n", err);
 		return err;
 	}
 
-	*hclk = devm_clk_get(&pdev->dev, "hclk");
 	if (IS_ERR(*hclk)) {
 		err = PTR_ERR(*hclk);
 		dev_err(&pdev->dev, "failed to get hclk (%u)\n", err);
@@ -3107,15 +3120,23 @@ static const struct of_device_id macb_dt_ids[] = {
 MODULE_DEVICE_TABLE(of, macb_dt_ids);
 #endif /* CONFIG_OF */
 
+static const struct macb_config default_gem_config = {
+	.caps = MACB_CAPS_GIGABIT_MODE_AVAILABLE | MACB_CAPS_JUMBO,
+	.dma_burst_length = 16,
+	.clk_init = macb_clk_init,
+	.init = macb_init,
+	.jumbo_max_len = 10240,
+};
+
 static int macb_probe(struct platform_device *pdev)
 {
+	const struct macb_config *macb_config = &default_gem_config;
 	int (*clk_init)(struct platform_device *, struct clk **,
 			struct clk **, struct clk **,  struct clk **)
-					      = macb_clk_init;
-	int (*init)(struct platform_device *) = macb_init;
+					      = macb_config->clk_init;
+	int (*init)(struct platform_device *) = macb_config->init;
 	struct device_node *np = pdev->dev.of_node;
 	struct device_node *phy_node;
-	const struct macb_config *macb_config = NULL;
 	struct clk *pclk, *hclk = NULL, *tx_clk = NULL, *rx_clk = NULL;
 	unsigned int queue_mask, num_queues;
 	struct macb_platform_data *pdata;

drivers/net/ethernet/cadence/macb_pci.c

@@ -0,0 +1,153 @@
+/**
+ * macb_pci.c - Cadence GEM PCI wrapper.
+ *
+ * Copyright (C) 2016 Cadence Design Systems - http://www.cadence.com
+ *
+ * Authors: Rafal Ozieblo <rafalo@cadence.com>
+ *	    Bartosz Folta <bfolta@cadence.com>
+ *
+ * This program is free software: you can redistribute it and/or modify
+ * it under the terms of the GNU General Public License version 2  of
+ * the License as published by the Free Software Foundation.
+ *
+ * This program is distributed in the hope that it will be useful,
+ * but WITHOUT ANY WARRANTY; without even the implied warranty of
+ * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the
+ * GNU General Public License for more details.
+ *
+ * You should have received a copy of the GNU General Public License
+ * along with this program.  If not, see <http://www.gnu.org/licenses/>.
+ */
+
+#include <linux/clk.h>
+#include <linux/clk-provider.h>
+#include <linux/etherdevice.h>
+#include <linux/module.h>
+#include <linux/pci.h>
+#include <linux/platform_data/macb.h>
+#include <linux/platform_device.h>
+#include "macb.h"
+
+#define PCI_DRIVER_NAME "macb_pci"
+#define PLAT_DRIVER_NAME "macb"
+
+#define CDNS_VENDOR_ID 0x17cd
+#define CDNS_DEVICE_ID 0xe007
+
+#define GEM_PCLK_RATE 50000000
+#define GEM_HCLK_RATE 50000000
+
+static int macb_probe(struct pci_dev *pdev, const struct pci_device_id *id)
+{
+	int err;
+	struct platform_device *plat_dev;
+	struct platform_device_info plat_info;
+	struct macb_platform_data plat_data;
+	struct resource res[2];
+
+	/* sanity check */
+	if (!id)
+		return -EINVAL;
+
+	/* enable pci device */
+	err = pci_enable_device(pdev);
+	if (err < 0) {
+		dev_err(&pdev->dev, "Enabling PCI device has failed: 0x%04X",
+			err);
+		return -EACCES;
+	}
+
+	pci_set_master(pdev);
+
+	/* set up resources */
+	memset(res, 0x00, sizeof(struct resource) * ARRAY_SIZE(res));
+	res[0].start = pdev->resource[0].start;
+	res[0].end = pdev->resource[0].end;
+	res[0].name = PCI_DRIVER_NAME;
+	res[0].flags = IORESOURCE_MEM;
+	res[1].start = pdev->irq;
+	res[1].name = PCI_DRIVER_NAME;
+	res[1].flags = IORESOURCE_IRQ;
+
+	dev_info(&pdev->dev, "EMAC physical base addr = 0x%p\n",
+		 (void *)(uintptr_t)pci_resource_start(pdev, 0));
+
+	/* set up macb platform data */
+	memset(&plat_data, 0, sizeof(plat_data));
+
+	/* initialize clocks */
+	plat_data.pclk = clk_register_fixed_rate(&pdev->dev, "pclk", NULL, 0,
+						 GEM_PCLK_RATE);
+	if (IS_ERR(plat_data.pclk)) {
+		err = PTR_ERR(plat_data.pclk);
+		goto err_pclk_register;
+	}
+
+	plat_data.hclk = clk_register_fixed_rate(&pdev->dev, "hclk", NULL, 0,
+						 GEM_HCLK_RATE);
+	if (IS_ERR(plat_data.hclk)) {
+		err = PTR_ERR(plat_data.hclk);
+		goto err_hclk_register;
+	}
+
+	/* set up platform device info */
+	memset(&plat_info, 0, sizeof(plat_info));
+	plat_info.parent = &pdev->dev;
+	plat_info.fwnode = pdev->dev.fwnode;
+	plat_info.name = PLAT_DRIVER_NAME;
+	plat_info.id = pdev->devfn;
+	plat_info.res = res;
+	plat_info.num_res = ARRAY_SIZE(res);
+	plat_info.data = &plat_data;
+	plat_info.size_data = sizeof(plat_data);
+	plat_info.dma_mask = DMA_BIT_MASK(32);
+
+	/* register platform device */
+	plat_dev = platform_device_register_full(&plat_info);
+	if (IS_ERR(plat_dev)) {
+		err = PTR_ERR(plat_dev);
+		goto err_plat_dev_register;
+	}
+
+	pci_set_drvdata(pdev, plat_dev);
+
+	return 0;
+
+err_plat_dev_register:
+	clk_unregister(plat_data.hclk);
+
+err_hclk_register:
+	clk_unregister(plat_data.pclk);
+
+err_pclk_register:
+	pci_disable_device(pdev);
+	return err;
+}
+
+static void macb_remove(struct pci_dev *pdev)
+{
+	struct platform_device *plat_dev = pci_get_drvdata(pdev);
+	struct macb_platform_data *plat_data = dev_get_platdata(&plat_dev->dev);
+
+	platform_device_unregister(plat_dev);
+	pci_disable_device(pdev);
+	clk_unregister(plat_data->pclk);
+	clk_unregister(plat_data->hclk);
+}
+
+static struct pci_device_id dev_id_table[] = {
+	{ PCI_DEVICE(CDNS_VENDOR_ID, CDNS_DEVICE_ID), },
+	{ 0, }
+};
+
+static struct pci_driver macb_pci_driver = {
+	.name     = PCI_DRIVER_NAME,
+	.id_table = dev_id_table,
+	.probe    = macb_probe,
+	.remove	  = macb_remove,
+};
+
+module_pci_driver(macb_pci_driver);
+MODULE_DEVICE_TABLE(pci, dev_id_table);
+MODULE_LICENSE("GPL");
+MODULE_DESCRIPTION("Cadence NIC PCI wrapper");

include/linux/platform_data/macb.h

@@ -8,6 +8,8 @@
 #ifndef __MACB_PDATA_H__
 #define __MACB_PDATA_H__
 
+#include <linux/clk.h>
+
 /**
  * struct macb_platform_data - platform data for MACB Ethernet
  * @phy_mask:		phy mask passed when register the MDIO bus
@@ -15,12 +17,16 @@
  * @phy_irq_pin:	PHY IRQ
  * @is_rmii:		using RMII interface?
  * @rev_eth_addr:	reverse Ethernet address byte order
+ * @pclk:		platform clock
+ * @hclk:		AHB clock
  */
 struct macb_platform_data {
 	u32		phy_mask;
 	int		phy_irq_pin;
 	u8		is_rmii;
 	u8		rev_eth_addr;
+	struct clk	*pclk;
+	struct clk	*hclk;
 };
 
 #endif /* __MACB_PDATA_H__ */