be2net: clear promiscuous bits in adapter->flags while disabling promiscuous mode

We should clear promiscuous bits in adapter->flags while disabling promiscuous
mode. Else we will not put interface back into VLAN promisc mode if the vlans
already added exceeds the maximum limit.

Signed-off-by: Kalesh AP <kalesh.purayil@emulex.com>
Signed-off-by: Somnath Kotur <somnath.kotur@emulex.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/emulex/benet/be_main.c

@@ -1157,6 +1157,14 @@ ret:
 	return status;
 }
 
+static void be_clear_promisc(struct be_adapter *adapter)
+{
+	adapter->promiscuous = false;
+	adapter->flags &= ~BE_FLAGS_VLAN_PROMISC;
+
+	be_cmd_rx_filter(adapter, IFF_PROMISC, OFF);
+}
+
 static void be_set_rx_mode(struct net_device *netdev)
 {
 	struct be_adapter *adapter = netdev_priv(netdev);
@@ -1170,9 +1178,7 @@ static void be_set_rx_mode(struct net_device *netdev)
 
 	/* BE was previously in promiscuous mode; disable it */
 	if (adapter->promiscuous) {
-		adapter->promiscuous = false;
-		be_cmd_rx_filter(adapter, IFF_PROMISC, OFF);
-
+		be_clear_promisc(adapter);
 		if (adapter->vlans_added)
 			be_vid_config(adapter);
 	}