pinctrl: qcom: spmi-gpio: Update GPIO EN_CTL when setting pin config

GPIO is expected to be disabled iff PIN_CONFIG_BIAS_HIGH_IMPEDANCE is
configured. Update is_enabled flag in config_set() so that it can
reflect GPIO status correctly. Also modify EN_CTL register based on
is_enabled flag in config_set() to configure the GPIO properly.

Signed-off-by: Fenglin Wu <fenglinw@codeaurora.org>
Acked-by: Bjorn Andersson <bjorn.andersson@linaro.org>
Signed-off-by: Linus Walleij <linus.walleij@linaro.org>

drivers/pinctrl/qcom/pinctrl-spmi-gpio.c

@@ -453,6 +453,7 @@ static int pmic_gpio_config_set(struct pinctrl_dev *pctldev, unsigned int pin,
 
 	pad = pctldev->desc->pins[pin].drv_data;
 
+	pad->is_enabled = true;
 	for (i = 0; i < nconfs; i++) {
 		param = pinconf_to_config_param(configs[i]);
 		arg = pinconf_to_config_argument(configs[i]);
@@ -600,6 +601,10 @@ static int pmic_gpio_config_set(struct pinctrl_dev *pctldev, unsigned int pin,
 			return ret;
 	}
 
+	val = pad->is_enabled << PMIC_GPIO_REG_MASTER_EN_SHIFT;
+
+	ret = pmic_gpio_write(state, pad, PMIC_GPIO_REG_EN_CTL, val);
+
 	return ret;
 }