Revert "ravb: add workaround for clock when resuming with WoL enabled"

This reverts commit fbf3d034f2ff6264183cfa6845770e8cc2a986c8.

As of commit 560869100b99a3da ("clk: renesas: cpg-mssr: Restore module
clocks during resume"), the workaround is no longer needed.

Signed-off-by: Geert Uytterhoeven <geert+renesas@glider.be>
Reviewed-by: Niklas Söderlund <niklas.soderlund+renesas@ragnatech.se>
Acked-by: Sergei Shtylyov <sergei.shtylyov@cogentembedded.com>
Signed-off-by: David S. Miller <davem@davemloft.net>

drivers/net/ethernet/renesas/ravb_main.c

@@ -2308,32 +2308,9 @@ static int __maybe_unused ravb_resume(struct device *dev)
 	struct ravb_private *priv = netdev_priv(ndev);
 	int ret = 0;
 
-	if (priv->wol_enabled) {
-		/* Reduce the usecount of the clock to zero and then
-		 * restore it to its original value. This is done to force
-		 * the clock to be re-enabled which is a workaround
-		 * for renesas-cpg-mssr driver which do not enable clocks
-		 * when resuming from PSCI suspend/resume.
-		 *
-		 * Without this workaround the driver fails to communicate
-		 * with the hardware if WoL was enabled when the system
-		 * entered PSCI suspend. This is due to that if WoL is enabled
-		 * we explicitly keep the clock from being turned off when
-		 * suspending, but in PSCI sleep power is cut so the clock
-		 * is disabled anyhow, the clock driver is not aware of this
-		 * so the clock is not turned back on when resuming.
-		 *
-		 * TODO: once the renesas-cpg-mssr suspend/resume is working
-		 *       this clock dance should be removed.
-		 */
-		clk_disable(priv->clk);
-		clk_disable(priv->clk);
-		clk_enable(priv->clk);
-		clk_enable(priv->clk);
-
-		/* Set reset mode to rearm the WoL logic */
+	/* If WoL is enabled set reset mode to rearm the WoL logic */
+	if (priv->wol_enabled)
 		ravb_write(ndev, CCC_OPC_RESET, CCC);
-	}
 
 	/* All register have been reset to default values.
 	 * Restore all registers which where setup at probe time and