regulator: pfuze100: add enable/disable for switch

Add enable/disable support for switch regulator on pfuze100.

Based on Robin Gong's patch from the NXP kernel tree.

Signed-off-by: Anson Huang <Anson.Huang@nxp.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

drivers/regulator/pfuze100-regulator.c

@@ -155,6 +155,9 @@ static const struct regulator_ops pfuze100_fixed_regulator_ops = {
 };
 
 static const struct regulator_ops pfuze100_sw_regulator_ops = {
+	.enable = regulator_enable_regmap,
+	.disable = regulator_disable_regmap,
+	.is_enabled = regulator_is_enabled_regmap,
 	.list_voltage = regulator_list_voltage_linear,
 	.set_voltage_sel = regulator_set_voltage_sel_regmap,
 	.get_voltage_sel = regulator_get_voltage_sel_regmap,
@@ -200,6 +203,11 @@ static const struct regulator_ops pfuze100_swb_regulator_ops = {
 			.uV_step = (step),	\
 			.vsel_reg = (base) + PFUZE100_VOL_OFFSET,	\
 			.vsel_mask = 0x3f,	\
+			.enable_reg = (base) + PFUZE100_MODE_OFFSET,	\
+			.enable_val = 0xc,	\
+			.disable_val = 0x0,	\
+			.enable_mask = 0xf,	\
+			.enable_time = 500,	\
 		},	\
 		.stby_reg = (base) + PFUZE100_STANDBY_OFFSET,	\
 		.stby_mask = 0x3f,	\