Merge back earlier cpufreq material for v4.4.

drivers/cpufreq/cpufreq_conservative.c

@@ -23,6 +23,19 @@
 
 static DEFINE_PER_CPU(struct cs_cpu_dbs_info_s, cs_cpu_dbs_info);
 
+static int cs_cpufreq_governor_dbs(struct cpufreq_policy *policy,
+				   unsigned int event);
+
+#ifndef CONFIG_CPU_FREQ_DEFAULT_GOV_CONSERVATIVE
+static
+#endif
+struct cpufreq_governor cpufreq_gov_conservative = {
+	.name			= "conservative",
+	.governor		= cs_cpufreq_governor_dbs,
+	.max_transition_latency	= TRANSITION_LATENCY_LIMIT,
+	.owner			= THIS_MODULE,
+};
+
 static inline unsigned int get_freq_target(struct cs_dbs_tuners *cs_tuners,
 					   struct cpufreq_policy *policy)
 {
@@ -119,12 +132,14 @@ static int dbs_cpufreq_notifier(struct notifier_block *nb, unsigned long val,
 	struct cpufreq_freqs *freq = data;
 	struct cs_cpu_dbs_info_s *dbs_info =
 					&per_cpu(cs_cpu_dbs_info, freq->cpu);
-	struct cpufreq_policy *policy;
+	struct cpufreq_policy *policy = cpufreq_cpu_get_raw(freq->cpu);
 
-	if (!dbs_info->enable)
+	if (!policy)
 		return 0;
 
-	policy = dbs_info->cdbs.shared->policy;
+	/* policy isn't governed by conservative governor */
+	if (policy->governor != &cpufreq_gov_conservative)
+		return 0;
 
 	/*
 	 * we only care if our internally tracked freq moves outside the 'valid'
@@ -367,16 +382,6 @@ static int cs_cpufreq_governor_dbs(struct cpufreq_policy *policy,
 	return cpufreq_governor_dbs(policy, &cs_dbs_cdata, event);
 }
 
-#ifndef CONFIG_CPU_FREQ_DEFAULT_GOV_CONSERVATIVE
-static
-#endif
-struct cpufreq_governor cpufreq_gov_conservative = {
-	.name			= "conservative",
-	.governor		= cs_cpufreq_governor_dbs,
-	.max_transition_latency	= TRANSITION_LATENCY_LIMIT,
-	.owner			= THIS_MODULE,
-};
-
 static int __init cpufreq_gov_dbs_init(void)
 {
 	return cpufreq_register_governor(&cpufreq_gov_conservative);

drivers/cpufreq/cpufreq_governor.c

@@ -463,7 +463,6 @@ static int cpufreq_governor_start(struct cpufreq_policy *policy,
 			cdata->get_cpu_dbs_info_s(cpu);
 
 		cs_dbs_info->down_skip = 0;
-		cs_dbs_info->enable = 1;
 		cs_dbs_info->requested_freq = policy->cur;
 	} else {
 		struct od_ops *od_ops = cdata->gov_ops;
@@ -482,9 +481,7 @@ static int cpufreq_governor_start(struct cpufreq_policy *policy,
 static int cpufreq_governor_stop(struct cpufreq_policy *policy,
 				 struct dbs_data *dbs_data)
 {
-	struct common_dbs_data *cdata = dbs_data->cdata;
-	unsigned int cpu = policy->cpu;
-	struct cpu_dbs_info *cdbs = cdata->get_cpu_cdbs(cpu);
+	struct cpu_dbs_info *cdbs = dbs_data->cdata->get_cpu_cdbs(policy->cpu);
 	struct cpu_common_dbs_info *shared = cdbs->shared;
 
 	/* State should be equivalent to START */
@@ -493,13 +490,6 @@ static int cpufreq_governor_stop(struct cpufreq_policy *policy,
 
 	gov_cancel_work(dbs_data, policy);
 
-	if (cdata->governor == GOV_CONSERVATIVE) {
-		struct cs_cpu_dbs_info_s *cs_dbs_info =
-			cdata->get_cpu_dbs_info_s(cpu);
-
-		cs_dbs_info->enable = 0;
-	}
-
 	shared->policy = NULL;
 	mutex_destroy(&shared->timer_mutex);
 	return 0;

drivers/cpufreq/cpufreq_governor.h

@@ -170,7 +170,6 @@ struct cs_cpu_dbs_info_s {
 	struct cpu_dbs_info cdbs;
 	unsigned int down_skip;
 	unsigned int requested_freq;
-	unsigned int enable:1;
 };
 
 /* Per policy Governors sysfs tunables */

drivers/cpufreq/imx6q-cpufreq.c

@@ -30,6 +30,10 @@ static struct clk *pll1_sw_clk;
 static struct clk *step_clk;
 static struct clk *pll2_pfd2_396m_clk;
 
+/* clk used by i.MX6UL */
+static struct clk *pll2_bus_clk;
+static struct clk *secondary_sel_clk;
+
 static struct device *cpu_dev;
 static bool free_opp;
 static struct cpufreq_frequency_table *freq_table;
@@ -91,16 +95,36 @@ static int imx6q_set_target(struct cpufreq_policy *policy, unsigned int index)
 	 * The setpoints are selected per PLL/PDF frequencies, so we need to
 	 * reprogram PLL for frequency scaling.  The procedure of reprogramming
 	 * PLL1 is as below.
-	 *
+	 * For i.MX6UL, it has a secondary clk mux, the cpu frequency change
+	 * flow is slightly different from other i.MX6 OSC.
+	 * The cpu frequeny change flow for i.MX6(except i.MX6UL) is as below:
 	 *  - Enable pll2_pfd2_396m_clk and reparent pll1_sw_clk to it
 	 *  - Reprogram pll1_sys_clk and reparent pll1_sw_clk back to it
 	 *  - Disable pll2_pfd2_396m_clk
 	 */
-	clk_set_parent(step_clk, pll2_pfd2_396m_clk);
-	clk_set_parent(pll1_sw_clk, step_clk);
-	if (freq_hz > clk_get_rate(pll2_pfd2_396m_clk)) {
-		clk_set_rate(pll1_sys_clk, new_freq * 1000);
+	if (of_machine_is_compatible("fsl,imx6ul")) {
+		/*
+		 * When changing pll1_sw_clk's parent to pll1_sys_clk,
+		 * CPU may run at higher than 528MHz, this will lead to
+		 * the system unstable if the voltage is lower than the
+		 * voltage of 528MHz, so lower the CPU frequency to one
+		 * half before changing CPU frequency.
+		 */
+		clk_set_rate(arm_clk, (old_freq >> 1) * 1000);
 		clk_set_parent(pll1_sw_clk, pll1_sys_clk);
+		if (freq_hz > clk_get_rate(pll2_pfd2_396m_clk))
+			clk_set_parent(secondary_sel_clk, pll2_bus_clk);
+		else
+			clk_set_parent(secondary_sel_clk, pll2_pfd2_396m_clk);
+		clk_set_parent(step_clk, secondary_sel_clk);
+		clk_set_parent(pll1_sw_clk, step_clk);
+	} else {
+		clk_set_parent(step_clk, pll2_pfd2_396m_clk);
+		clk_set_parent(pll1_sw_clk, step_clk);
+		if (freq_hz > clk_get_rate(pll2_pfd2_396m_clk)) {
+			clk_set_rate(pll1_sys_clk, new_freq * 1000);
+			clk_set_parent(pll1_sw_clk, pll1_sys_clk);
+		}
 	}
 
 	/* Ensure the arm clock divider is what we expect */
@@ -186,6 +210,16 @@ static int imx6q_cpufreq_probe(struct platform_device *pdev)
 		goto put_clk;
 	}
 
+	if (of_machine_is_compatible("fsl,imx6ul")) {
+		pll2_bus_clk = clk_get(cpu_dev, "pll2_bus");
+		secondary_sel_clk = clk_get(cpu_dev, "secondary_sel");
+		if (IS_ERR(pll2_bus_clk) || IS_ERR(secondary_sel_clk)) {
+			dev_err(cpu_dev, "failed to get clocks specific to imx6ul\n");
+			ret = -ENOENT;
+			goto put_clk;
+		}
+	}
+
 	arm_reg = regulator_get(cpu_dev, "arm");
 	pu_reg = regulator_get_optional(cpu_dev, "pu");
 	soc_reg = regulator_get(cpu_dev, "soc");
@@ -331,6 +365,10 @@ put_clk:
 		clk_put(step_clk);
 	if (!IS_ERR(pll2_pfd2_396m_clk))
 		clk_put(pll2_pfd2_396m_clk);
+	if (!IS_ERR(pll2_bus_clk))
+		clk_put(pll2_bus_clk);
+	if (!IS_ERR(secondary_sel_clk))
+		clk_put(secondary_sel_clk);
 	of_node_put(np);
 	return ret;
 }
@@ -350,6 +388,8 @@ static int imx6q_cpufreq_remove(struct platform_device *pdev)
 	clk_put(pll1_sw_clk);
 	clk_put(step_clk);
 	clk_put(pll2_pfd2_396m_clk);
+	clk_put(pll2_bus_clk);
+	clk_put(secondary_sel_clk);
 
 	return 0;
 }

drivers/cpufreq/integrator-cpufreq.c

@@ -221,6 +221,8 @@ static const struct of_device_id integrator_cpufreq_match[] = {
 	{ },
 };
 
+MODULE_DEVICE_TABLE(of, integrator_cpufreq_match);
+
 static struct platform_driver integrator_cpufreq_driver = {
 	.driver = {
 		.name = "integrator-cpufreq",

drivers/cpufreq/powernv-cpufreq.c

@@ -327,8 +327,14 @@ static void powernv_cpufreq_throttle_check(void *data)
 		if (chips[i].throttled)
 			goto next;
 		chips[i].throttled = true;
-		pr_info("CPU %d on Chip %u has Pmax reduced to %d\n", cpu,
-			chips[i].id, pmsr_pmax);
+		if (pmsr_pmax < powernv_pstate_info.nominal)
+			pr_crit("CPU %d on Chip %u has Pmax reduced below nominal frequency (%d < %d)\n",
+				cpu, chips[i].id, pmsr_pmax,
+				powernv_pstate_info.nominal);
+		else
+			pr_info("CPU %d on Chip %u has Pmax reduced below turbo frequency (%d < %d)\n",
+				cpu, chips[i].id, pmsr_pmax,
+				powernv_pstate_info.max);
 	} else if (chips[i].throttled) {
 		chips[i].throttled = false;
 		pr_info("CPU %d on Chip %u has Pmax restored to %d\n", cpu,

drivers/cpufreq/tegra20-cpufreq.c

@@ -175,9 +175,7 @@ static struct cpufreq_driver tegra_cpufreq_driver = {
 	.exit			= tegra_cpu_exit,
 	.name			= "tegra",
 	.attr			= cpufreq_generic_attr,
-#ifdef CONFIG_PM
 	.suspend		= cpufreq_generic_suspend,
-#endif
 };
 
 static int __init tegra_cpufreq_init(void)