iwlwifi: mvm: use proper sta_addr in firmware API

There's no point to declare an address as a __le32/__le16
and then only take a pointer to it anyway, change that to
just a sta_addr[ETH_ALEN].

Signed-off-by: Johannes Berg <johannes.berg@intel.com>
Signed-off-by: Luca Coelho <luciano.coelho@intel.com>

drivers/net/wireless/intel/iwlwifi/mvm/fw-api-tx.h

@@ -594,8 +594,7 @@ struct iwl_mvm_tx_resp {
 /**
  * struct iwl_mvm_ba_notif - notifies about reception of BA
  * ( BA_NOTIF = 0xc5 )
- * @sta_addr_lo32: lower 32 bits of the MAC address
- * @sta_addr_hi16: upper 16 bits of the MAC address
+ * @sta_addr: MAC address
  * @sta_id: Index of recipient (BA-sending) station in fw's station table
  * @tid: tid of the session
  * @seq_ctl:
@@ -609,8 +608,7 @@ struct iwl_mvm_tx_resp {
  *	for Tx-ing then this value will be set to 0 by FW.
  */
 struct iwl_mvm_ba_notif {
-	__le32 sta_addr_lo32;
-	__le16 sta_addr_hi16;
+	u8 sta_addr[ETH_ALEN];
 	__le16 reserved;
 
 	u8 sta_id;

drivers/net/wireless/intel/iwlwifi/mvm/tx.c

@@ -1850,7 +1850,7 @@ out:
 
 	IWL_DEBUG_TX_REPLY(mvm,
 			   "BA_NOTIFICATION Received from %pM, sta_id = %d\n",
-			   (u8 *)&ba_notif->sta_addr_lo32, ba_notif->sta_id);
+			   ba_notif->sta_addr, ba_notif->sta_id);
 
 	IWL_DEBUG_TX_REPLY(mvm,
 			   "TID = %d, SeqCtl = %d, bitmap = 0x%llx, scd_flow = %d, scd_ssn = %d sent:%d, acked:%d\n",