ath10k: move uart pin config into hw_params

This will make it possible to easily support
different hardware with different uart pin
configuration.

Signed-off-by: Michal Kazior <michal.kazior@tieto.com>
Signed-off-by: Kalle Valo <kvalo@qca.qualcomm.com>

drivers/net/wireless/ath/ath10k/core.c

@@ -49,6 +49,7 @@ static const struct ath10k_hw_params ath10k_hw_params_list[] = {
 		.id = QCA988X_HW_2_0_VERSION,
 		.name = "qca988x hw2.0",
 		.patch_load_addr = QCA988X_HW_2_0_PATCH_LOAD_ADDR,
+		.uart_pin = 7,
 		.fw = {
 			.dir = QCA988X_HW_2_0_FW_DIR,
 			.fw = QCA988X_HW_2_0_FW_FILE,
@@ -766,7 +767,7 @@ static int ath10k_init_uart(struct ath10k *ar)
 	if (!uart_print)
 		return 0;
 
-	ret = ath10k_bmi_write32(ar, hi_dbg_uart_txpin, 7);
+	ret = ath10k_bmi_write32(ar, hi_dbg_uart_txpin, ar->hw_params.uart_pin);
 	if (ret) {
 		ath10k_warn(ar, "could not enable UART prints (%d)\n", ret);
 		return ret;

drivers/net/wireless/ath/ath10k/core.h

@@ -483,6 +483,7 @@ struct ath10k {
 		u32 id;
 		const char *name;
 		u32 patch_load_addr;
+		int uart_pin;
 
 		struct ath10k_hw_params_fw {
 			const char *dir;