[SCSI] bfa: Observed auto D-port mode instead of manual

Observed Auto mode in the HBA side while doing manual D-Port test on the
switch side. Mode is not passed to BFA from firmware when the test is
triggered by switch side. BFA just blindly using Auto mode.

Signed-off-by: Vijaya Mohan Guvva <vmohan@brocade.com>
Signed-off-by: James Bottomley <JBottomley@Parallels.com>

drivers/scsi/bfa/bfa_svc.c

@@ -6758,7 +6758,7 @@ bfa_dport_scn(struct bfa_dport_s *dport, struct bfi_diag_dport_scn_s *msg)
 		dport->rp_pwwn = msg->info.teststart.pwwn;
 		dport->rp_nwwn = msg->info.teststart.nwwn;
 		dport->lpcnt = cpu_to_be32(msg->info.teststart.numfrm);
-		bfa_dport_result_start(dport, BFA_DPORT_OPMODE_AUTO);
+		bfa_dport_result_start(dport, msg->info.teststart.mode);
 		break;
 
 	case BFI_DPORT_SCN_SUBTESTSTART:

drivers/scsi/bfa/bfi.h

@@ -1144,7 +1144,8 @@ struct bfi_diag_dport_scn_teststart_s {
 	wwn_t	pwwn;	/* switch port wwn. 8 bytes */
 	wwn_t	nwwn;	/* switch node wwn. 8 bytes */
 	u8	type;	/* bfa_diag_dport_test_type_e */
-	u8	rsvd[3];
+	u8	mode;	/* bfa_diag_dport_test_opmode */
+	u8	rsvd[2];
 	u32	numfrm; /* from switch uint in 1M */
 };