spi: Add can_dma like interface for spi_flash_read

Add an interface analogous to ->can_dma() for spi_flash_read()
interface. This will enable SPI controller drivers to inform SPI core
when not to do DMA mappings.

Signed-off-by: Vignesh R <vigneshr@ti.com>
Signed-off-by: Mark Brown <broonie@kernel.org>

drivers/spi/spi.c

@@ -2811,7 +2811,7 @@ int spi_flash_read(struct spi_device *spi,
 
 	mutex_lock(&master->bus_lock_mutex);
 	mutex_lock(&master->io_mutex);
-	if (master->dma_rx) {
+	if (master->dma_rx && master->spi_flash_can_dma(spi, msg)) {
 		rx_dev = master->dma_rx->device->dev;
 		ret = spi_map_buf(master, rx_dev, &msg->rx_sg,
 				  msg->buf, msg->len,

include/linux/spi/spi.h

@@ -375,6 +375,8 @@ static inline void spi_unregister_driver(struct spi_driver *sdrv)
  * @unprepare_message: undo any work done by prepare_message().
  * @spi_flash_read: to support spi-controller hardwares that provide
  *                  accelerated interface to read from flash devices.
+ * @spi_flash_can_dma: analogous to can_dma() interface, but for
+ *		       controllers implementing spi_flash_read.
  * @flash_read_supported: spi device supports flash read
  * @cs_gpios: Array of GPIOs to use as chip select lines; one per CS
  *	number. Any individual value may be -ENOENT for CS lines that
@@ -538,6 +540,8 @@ struct spi_master {
 				 struct spi_message *message);
 	int (*spi_flash_read)(struct  spi_device *spi,
 			      struct spi_flash_read_message *msg);
+	bool (*spi_flash_can_dma)(struct spi_device *spi,
+				  struct spi_flash_read_message *msg);
 	bool (*flash_read_supported)(struct spi_device *spi);
 
 	/*