|
@@ -73,9 +73,14 @@
|
|
|
#define REG_SET_MASK(r, m, v) (((r) & ~(m)) | \
|
|
|
(((v) & (m >> (ffs(m) - 1))) << (ffs(m) - 1)))
|
|
|
|
|
|
+static const int min_low_temp = -127000;
|
|
|
+static const int max_high_temp = 127000;
|
|
|
+
|
|
|
struct tegra_thermctl_zone {
|
|
|
void __iomem *reg;
|
|
|
- u32 mask;
|
|
|
+ struct device *dev;
|
|
|
+ struct thermal_zone_device *tz;
|
|
|
+ const struct tegra_tsensor_group *sg;
|
|
|
};
|
|
|
|
|
|
struct tegra_soctherm {
|
|
@@ -145,22 +150,158 @@ static int tegra_thermctl_get_temp(void *data, int *out_temp)
|
|
|
u32 val;
|
|
|
|
|
|
val = readl(zone->reg);
|
|
|
- val = REG_GET_MASK(val, zone->mask);
|
|
|
+ val = REG_GET_MASK(val, zone->sg->sensor_temp_mask);
|
|
|
*out_temp = translate_temp(val);
|
|
|
|
|
|
return 0;
|
|
|
}
|
|
|
|
|
|
+static int
|
|
|
+thermtrip_program(struct device *dev, const struct tegra_tsensor_group *sg,
|
|
|
+ int trip_temp);
|
|
|
+
|
|
|
+static int tegra_thermctl_set_trip_temp(void *data, int trip, int temp)
|
|
|
+{
|
|
|
+ struct tegra_thermctl_zone *zone = data;
|
|
|
+ struct thermal_zone_device *tz = zone->tz;
|
|
|
+ const struct tegra_tsensor_group *sg = zone->sg;
|
|
|
+ struct device *dev = zone->dev;
|
|
|
+ enum thermal_trip_type type;
|
|
|
+ int ret;
|
|
|
+
|
|
|
+ if (!tz)
|
|
|
+ return -EINVAL;
|
|
|
+
|
|
|
+ ret = tz->ops->get_trip_type(tz, trip, &type);
|
|
|
+ if (ret)
|
|
|
+ return ret;
|
|
|
+
|
|
|
+ if (type != THERMAL_TRIP_CRITICAL)
|
|
|
+ return 0;
|
|
|
+
|
|
|
+ return thermtrip_program(dev, sg, temp);
|
|
|
+}
|
|
|
+
|
|
|
static const struct thermal_zone_of_device_ops tegra_of_thermal_ops = {
|
|
|
.get_temp = tegra_thermctl_get_temp,
|
|
|
+ .set_trip_temp = tegra_thermctl_set_trip_temp,
|
|
|
};
|
|
|
|
|
|
+/**
|
|
|
+ * enforce_temp_range() - check and enforce temperature range [min, max]
|
|
|
+ * @trip_temp: the trip temperature to check
|
|
|
+ *
|
|
|
+ * Checks and enforces the permitted temperature range that SOC_THERM
|
|
|
+ * HW can support This is
|
|
|
+ * done while taking care of precision.
|
|
|
+ *
|
|
|
+ * Return: The precision adjusted capped temperature in millicelsius.
|
|
|
+ */
|
|
|
+static int enforce_temp_range(struct device *dev, int trip_temp)
|
|
|
+{
|
|
|
+ int temp;
|
|
|
+
|
|
|
+ temp = clamp_val(trip_temp, min_low_temp, max_high_temp);
|
|
|
+ if (temp != trip_temp)
|
|
|
+ dev_info(dev, "soctherm: trip temperature %d forced to %d\n",
|
|
|
+ trip_temp, temp);
|
|
|
+ return temp;
|
|
|
+}
|
|
|
+
|
|
|
+/**
|
|
|
+ * thermtrip_program() - Configures the hardware to shut down the
|
|
|
+ * system if a given sensor group reaches a given temperature
|
|
|
+ * @dev: ptr to the struct device for the SOC_THERM IP block
|
|
|
+ * @sg: pointer to the sensor group to set the thermtrip temperature for
|
|
|
+ * @trip_temp: the temperature in millicelsius to trigger the thermal trip at
|
|
|
+ *
|
|
|
+ * Sets the thermal trip threshold of the given sensor group to be the
|
|
|
+ * @trip_temp. If this threshold is crossed, the hardware will shut
|
|
|
+ * down.
|
|
|
+ *
|
|
|
+ * Note that, although @trip_temp is specified in millicelsius, the
|
|
|
+ * hardware is programmed in degrees Celsius.
|
|
|
+ *
|
|
|
+ * Return: 0 upon success, or %-EINVAL upon failure.
|
|
|
+ */
|
|
|
+static int thermtrip_program(struct device *dev,
|
|
|
+ const struct tegra_tsensor_group *sg,
|
|
|
+ int trip_temp)
|
|
|
+{
|
|
|
+ struct tegra_soctherm *ts = dev_get_drvdata(dev);
|
|
|
+ int temp;
|
|
|
+ u32 r;
|
|
|
+
|
|
|
+ if (!dev || !sg)
|
|
|
+ return -EINVAL;
|
|
|
+
|
|
|
+ if (!sg->thermtrip_threshold_mask)
|
|
|
+ return -EINVAL;
|
|
|
+
|
|
|
+ temp = enforce_temp_range(dev, trip_temp) / ts->soc->thresh_grain;
|
|
|
+
|
|
|
+ r = readl(ts->regs + THERMCTL_THERMTRIP_CTL);
|
|
|
+ r = REG_SET_MASK(r, sg->thermtrip_threshold_mask, temp);
|
|
|
+ r = REG_SET_MASK(r, sg->thermtrip_enable_mask, 1);
|
|
|
+ r = REG_SET_MASK(r, sg->thermtrip_any_en_mask, 0);
|
|
|
+ writel(r, ts->regs + THERMCTL_THERMTRIP_CTL);
|
|
|
+
|
|
|
+ return 0;
|
|
|
+}
|
|
|
+
|
|
|
+/**
|
|
|
+ * tegra_soctherm_set_hwtrips() - set HW trip point from DT data
|
|
|
+ * @dev: struct device * of the SOC_THERM instance
|
|
|
+ *
|
|
|
+ * Configure the SOC_THERM HW trip points, setting "THERMTRIP"
|
|
|
+ * trip points , using "critical" type trip_temp from thermal
|
|
|
+ * zone.
|
|
|
+ * After they have been configured, THERMTRIP will take action
|
|
|
+ * when the configured SoC thermal sensor group reaches a
|
|
|
+ * certain temperature.
|
|
|
+ *
|
|
|
+ * Return: 0 upon success, or a negative error code on failure.
|
|
|
+ * "Success" does not mean that trips was enabled; it could also
|
|
|
+ * mean that no node was found in DT.
|
|
|
+ * THERMTRIP has been enabled successfully when a message similar to
|
|
|
+ * this one appears on the serial console:
|
|
|
+ * "thermtrip: will shut down when sensor group XXX reaches YYYYYY mC"
|
|
|
+ */
|
|
|
+static int tegra_soctherm_set_hwtrips(struct device *dev,
|
|
|
+ const struct tegra_tsensor_group *sg,
|
|
|
+ struct thermal_zone_device *tz)
|
|
|
+{
|
|
|
+ int temperature;
|
|
|
+ int ret;
|
|
|
+
|
|
|
+ ret = tz->ops->get_crit_temp(tz, &temperature);
|
|
|
+ if (ret) {
|
|
|
+ dev_warn(dev, "thermtrip: %s: missing critical temperature\n",
|
|
|
+ sg->name);
|
|
|
+ return ret;
|
|
|
+ }
|
|
|
+
|
|
|
+ ret = thermtrip_program(dev, sg, temperature);
|
|
|
+ if (ret) {
|
|
|
+ dev_err(dev, "thermtrip: %s: error during enable\n",
|
|
|
+ sg->name);
|
|
|
+ return ret;
|
|
|
+ }
|
|
|
+
|
|
|
+ dev_info(dev,
|
|
|
+ "thermtrip: will shut down when %s reaches %d mC\n",
|
|
|
+ sg->name, temperature);
|
|
|
+
|
|
|
+ return 0;
|
|
|
+}
|
|
|
+
|
|
|
#ifdef CONFIG_DEBUG_FS
|
|
|
static int regs_show(struct seq_file *s, void *data)
|
|
|
{
|
|
|
struct platform_device *pdev = s->private;
|
|
|
struct tegra_soctherm *ts = platform_get_drvdata(pdev);
|
|
|
const struct tegra_tsensor *tsensors = ts->soc->tsensors;
|
|
|
+ const struct tegra_tsensor_group **ttgs = ts->soc->ttgs;
|
|
|
u32 r, state;
|
|
|
int i;
|
|
|
|
|
@@ -236,6 +377,17 @@ static int regs_show(struct seq_file *s, void *data)
|
|
|
state = REG_GET_MASK(r, SENSOR_TEMP2_MEM_TEMP_MASK);
|
|
|
seq_printf(s, " MEM(%d)\n", translate_temp(state));
|
|
|
|
|
|
+ r = readl(ts->regs + THERMCTL_THERMTRIP_CTL);
|
|
|
+ state = REG_GET_MASK(r, ttgs[0]->thermtrip_any_en_mask);
|
|
|
+ seq_printf(s, "Thermtrip Any En(%d)\n", state);
|
|
|
+ for (i = 0; i < ts->soc->num_ttgs; i++) {
|
|
|
+ state = REG_GET_MASK(r, ttgs[i]->thermtrip_enable_mask);
|
|
|
+ seq_printf(s, " %s En(%d) ", ttgs[i]->name, state);
|
|
|
+ state = REG_GET_MASK(r, ttgs[i]->thermtrip_threshold_mask);
|
|
|
+ state *= ts->soc->thresh_grain;
|
|
|
+ seq_printf(s, "Thresh(%d)\n", state);
|
|
|
+ }
|
|
|
+
|
|
|
return 0;
|
|
|
}
|
|
|
|
|
@@ -394,8 +546,6 @@ static int tegra_soctherm_probe(struct platform_device *pdev)
|
|
|
writel(pdiv, tegra->regs + SENSOR_PDIV);
|
|
|
writel(hotspot, tegra->regs + SENSOR_HOTSPOT_OFF);
|
|
|
|
|
|
- /* Initialize thermctl sensors */
|
|
|
-
|
|
|
for (i = 0; i < soc->num_ttgs; ++i) {
|
|
|
struct tegra_thermctl_zone *zone =
|
|
|
devm_kzalloc(&pdev->dev, sizeof(*zone), GFP_KERNEL);
|
|
@@ -405,7 +555,8 @@ static int tegra_soctherm_probe(struct platform_device *pdev)
|
|
|
}
|
|
|
|
|
|
zone->reg = tegra->regs + soc->ttgs[i]->sensor_temp_offset;
|
|
|
- zone->mask = soc->ttgs[i]->sensor_temp_mask;
|
|
|
+ zone->dev = &pdev->dev;
|
|
|
+ zone->sg = soc->ttgs[i];
|
|
|
|
|
|
z = devm_thermal_zone_of_sensor_register(&pdev->dev,
|
|
|
soc->ttgs[i]->id, zone,
|
|
@@ -416,6 +567,11 @@ static int tegra_soctherm_probe(struct platform_device *pdev)
|
|
|
err);
|
|
|
goto disable_clocks;
|
|
|
}
|
|
|
+
|
|
|
+ zone->tz = z;
|
|
|
+
|
|
|
+ /* Configure hw trip points */
|
|
|
+ tegra_soctherm_set_hwtrips(&pdev->dev, soc->ttgs[i], z);
|
|
|
}
|
|
|
|
|
|
soctherm_debug_init(pdev);
|