md/raid1: add failfast handling for writes.

When writing to a fastfail device we use MD_FASTFAIL unless
it is the only device being written to.

For resync/recovery, assume there was a working device to
read from so always use REQ_FASTFAIL_DEV.

If a write for resync/recovery fails, we just fail the
device - there is not much else to do.

If a normal failfast write fails, but the device cannot be
failed (must be only one left), we queue for write error
handling.  This will call narrow_write_error() to retry the
write synchronously and without any FAILFAST flags.

Signed-off-by: NeilBrown <neilb@suse.com>
Signed-off-by: Shaohua Li <shli@fb.com>

drivers/md/raid1.c

@@ -422,7 +422,24 @@ static void raid1_end_write_request(struct bio *bio)
 			set_bit(MD_RECOVERY_NEEDED, &
 				conf->mddev->recovery);
 
-		set_bit(R1BIO_WriteError, &r1_bio->state);
+		if (test_bit(FailFast, &rdev->flags) &&
+		    (bio->bi_opf & MD_FAILFAST) &&
+		    /* We never try FailFast to WriteMostly devices */
+		    !test_bit(WriteMostly, &rdev->flags)) {
+			md_error(r1_bio->mddev, rdev);
+			if (!test_bit(Faulty, &rdev->flags))
+				/* This is the only remaining device,
+				 * We need to retry the write without
+				 * FailFast
+				 */
+				set_bit(R1BIO_WriteError, &r1_bio->state);
+			else {
+				/* Finished with this branch */
+				r1_bio->bios[mirror] = NULL;
+				to_put = bio;
+			}
+		} else
+			set_bit(R1BIO_WriteError, &r1_bio->state);
 	} else {
 		/*
 		 * Set R1BIO_Uptodate in our master bio, so that we
@@ -1392,6 +1409,10 @@ read_again:
 		mbio->bi_bdev = conf->mirrors[i].rdev->bdev;
 		mbio->bi_end_io	= raid1_end_write_request;
 		bio_set_op_attrs(mbio, op, do_flush_fua | do_sync);
+		if (test_bit(FailFast, &conf->mirrors[i].rdev->flags) &&
+		    !test_bit(WriteMostly, &conf->mirrors[i].rdev->flags) &&
+		    conf->raid_disks - mddev->degraded > 1)
+			mbio->bi_opf |= MD_FAILFAST;
 		mbio->bi_private = r1_bio;
 
 		atomic_inc(&r1_bio->remaining);
@@ -2060,6 +2081,9 @@ static void sync_request_write(struct mddev *mddev, struct r1bio *r1_bio)
 			continue;
 
 		bio_set_op_attrs(wbio, REQ_OP_WRITE, 0);
+		if (test_bit(FailFast, &conf->mirrors[i].rdev->flags))
+			wbio->bi_opf |= MD_FAILFAST;
+
 		wbio->bi_end_io = end_sync_write;
 		atomic_inc(&r1_bio->remaining);
 		md_sync_acct(conf->mirrors[i].rdev->bdev, bio_sectors(wbio));