wl12xx: AP-mode - configure HT rate support to the FW

Unconditionally configure HT rate support to the FW on all ACs
when starting the AP.

When 11n support is disabled by usermode (hostapd), each STA joining
the AP will appear as a non-HT STA. This will stop us from accidentally
transmitting using MCS rates.

Signed-off-by: Arik Nemtsov <arik@wizery.com>
Signed-off-by: Eliad Peller <eliad@wizery.com>
Signed-off-by: Luciano Coelho <coelho@ti.com>

drivers/net/wireless/wl12xx/conf.h

@@ -441,6 +441,11 @@ struct conf_rx_settings {
 	CONF_HW_BIT_RATE_36MBPS | CONF_HW_BIT_RATE_48MBPS |      \
 	CONF_HW_BIT_RATE_54MBPS)
 
+#define CONF_TX_MCS_RATES (CONF_HW_BIT_RATE_MCS_0 |              \
+	CONF_HW_BIT_RATE_MCS_1 | CONF_HW_BIT_RATE_MCS_2 |        \
+	CONF_HW_BIT_RATE_MCS_3 | CONF_HW_BIT_RATE_MCS_4 |        \
+	CONF_HW_BIT_RATE_MCS_5 | CONF_HW_BIT_RATE_MCS_6 |        \
+	CONF_HW_BIT_RATE_MCS_7)
 
 /*
  * Default rates for management traffic when operating in AP mode. This

drivers/net/wireless/wl12xx/init.c

@@ -515,6 +515,9 @@ int wl1271_init_ap_rates(struct wl1271 *wl)
 	else
 		supported_rates = CONF_TX_AP_ENABLED_RATES;
 
+	/* unconditionally enable HT rates */
+	supported_rates |= CONF_TX_MCS_RATES;
+
 	/* configure unicast TX rate classes */
 	for (i = 0; i < wl->conf.tx.ac_conf_count; i++) {
 		rc.enabled_rates = supported_rates;