mmc: sdhci: Factor out target_timeout calculation

Factor out the target_timeout calculation so it can be re-used.

Signed-off-by: Adrian Hunter <adrian.hunter@intel.com>
Signed-off-by: Kishon Vijay Abraham I <kishon@ti.com>
Signed-off-by: Ulf Hansson <ulf.hansson@linaro.org>

drivers/mmc/host/sdhci.c

@@ -709,6 +709,35 @@ static u32 sdhci_sdma_address(struct sdhci_host *host)
 		return sg_dma_address(host->data->sg);
 }
 
+static unsigned int sdhci_target_timeout(struct sdhci_host *host,
+					 struct mmc_command *cmd,
+					 struct mmc_data *data)
+{
+	unsigned int target_timeout;
+
+	/* timeout in us */
+	if (!data) {
+		target_timeout = cmd->busy_timeout * 1000;
+	} else {
+		target_timeout = DIV_ROUND_UP(data->timeout_ns, 1000);
+		if (host->clock && data->timeout_clks) {
+			unsigned long long val;
+
+			/*
+			 * data->timeout_clks is in units of clock cycles.
+			 * host->clock is in Hz.  target_timeout is in us.
+			 * Hence, us = 1000000 * cycles / Hz.  Round up.
+			 */
+			val = 1000000ULL * data->timeout_clks;
+			if (do_div(val, host->clock))
+				target_timeout++;
+			target_timeout += val;
+		}
+	}
+
+	return target_timeout;
+}
+
 static u8 sdhci_calc_timeout(struct sdhci_host *host, struct mmc_command *cmd,
 			     bool *too_big)
 {
@@ -732,24 +761,7 @@ static u8 sdhci_calc_timeout(struct sdhci_host *host, struct mmc_command *cmd,
 		return 0xE;
 
 	/* timeout in us */
-	if (!data)
-		target_timeout = cmd->busy_timeout * 1000;
-	else {
-		target_timeout = DIV_ROUND_UP(data->timeout_ns, 1000);
-		if (host->clock && data->timeout_clks) {
-			unsigned long long val;
-
-			/*
-			 * data->timeout_clks is in units of clock cycles.
-			 * host->clock is in Hz.  target_timeout is in us.
-			 * Hence, us = 1000000 * cycles / Hz.  Round up.
-			 */
-			val = 1000000ULL * data->timeout_clks;
-			if (do_div(val, host->clock))
-				target_timeout++;
-			target_timeout += val;
-		}
-	}
+	target_timeout = sdhci_target_timeout(host, cmd, data);
 
 	/*
 	 * Figure out needed cycles.