ixgbe: always call setup_mac_link for multispeed fiber

Remove the logic which would previously skip the link configuration
in the case where we are already at the requested speed in
ixgbe_setup_mac_link_multispeed_fiber().

By exiting early we are skipping the link configuration and as such
the driver may not always configure the PHY correctly for SFP+.

Signed-off-by: Emil Tantilov <emil.s.tantilov@intel.com>
Tested-by: Andrew Bowers <andrewx.bowers@intel.com>
Signed-off-by: Jeff Kirsher <jeffrey.t.kirsher@intel.com>

drivers/net/ethernet/intel/ixgbe/ixgbe_common.c

@@ -4121,15 +4121,6 @@ s32 ixgbe_setup_mac_link_multispeed_fiber(struct ixgbe_hw *hw,
 		speedcnt++;
 		highest_link_speed = IXGBE_LINK_SPEED_10GB_FULL;
 
-		/* If we already have link at this speed, just jump out */
-		status = hw->mac.ops.check_link(hw, &link_speed, &link_up,
-						false);
-		if (status)
-			return status;
-
-		if (link_speed == IXGBE_LINK_SPEED_10GB_FULL && link_up)
-			goto out;
-
 		/* Set the module link speed */
 		switch (hw->phy.media_type) {
 		case ixgbe_media_type_fiber:
@@ -4181,15 +4172,6 @@ s32 ixgbe_setup_mac_link_multispeed_fiber(struct ixgbe_hw *hw,
 		if (highest_link_speed == IXGBE_LINK_SPEED_UNKNOWN)
 			highest_link_speed = IXGBE_LINK_SPEED_1GB_FULL;
 
-		/* If we already have link at this speed, just jump out */
-		status = hw->mac.ops.check_link(hw, &link_speed, &link_up,
-						false);
-		if (status)
-			return status;
-
-		if (link_speed == IXGBE_LINK_SPEED_1GB_FULL && link_up)
-			goto out;
-
 		/* Set the module link speed */
 		switch (hw->phy.media_type) {
 		case ixgbe_media_type_fiber: