net/mlx5: Clean SRIOV eswitch resources upon VF creation failure

Upon sriov enable, eswitch is always enabled.
Currently, if enable hca failed over all VFs, we would skip eswitch
disable as part of sriov disable, which will lead to resources leak.

Fix it by disabling eswitch if it was enabled (use indication from
eswitch mode).

Fixes: 6b6adee3dad2 ('net/mlx5: SRIOV core code refactoring')
Signed-off-by: Eran Ben Elisha <eranbe@mellanox.com>
Signed-off-by: Noa Osherovich <noaos@mellanox.com>
Signed-off-by: Saeed Mahameed <saeedm@mellanox.com>

drivers/net/ethernet/mellanox/mlx5/core/eswitch.c

@@ -1668,7 +1668,8 @@ void mlx5_eswitch_disable_sriov(struct mlx5_eswitch *esw)
 	int i;
 
 	if (!esw || !MLX5_CAP_GEN(esw->dev, vport_group_manager) ||
-	    MLX5_CAP_GEN(esw->dev, port_type) != MLX5_CAP_PORT_TYPE_ETH)
+	    MLX5_CAP_GEN(esw->dev, port_type) != MLX5_CAP_PORT_TYPE_ETH ||
+	    esw->mode == SRIOV_NONE)
 		return;
 
 	esw_info(esw->dev, "disable SRIOV: active vports(%d) mode(%d)\n",

drivers/net/ethernet/mellanox/mlx5/core/sriov.c

@@ -88,7 +88,11 @@ static void mlx5_device_disable_sriov(struct mlx5_core_dev *dev)
 	int vf;
 
 	if (!sriov->enabled_vfs)
+#ifdef CONFIG_MLX5_CORE_EN
+		goto disable_sriov_resources;
+#else
 		return;
+#endif
 
 	for (vf = 0; vf < sriov->num_vfs; vf++) {
 		if (!sriov->vfs_ctx[vf].enabled)
@@ -103,6 +107,7 @@ static void mlx5_device_disable_sriov(struct mlx5_core_dev *dev)
 	}
 
 #ifdef CONFIG_MLX5_CORE_EN
+disable_sriov_resources:
 	mlx5_eswitch_disable_sriov(dev->priv.eswitch);
 #endif