Merge branch 'x86-pti-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/tip

Pull x86 page table isolation fixes from Thomas Gleixner:
 "A couple of urgent fixes for PTI:

   - Fix a PTE mismatch between user and kernel visible mapping of the
     cpu entry area (differs vs. the GLB bit) and causes a TLB mismatch
     MCE on older AMD K8 machines

   - Fix the misplaced CR3 switch in the SYSCALL compat entry code which
     causes access to unmapped kernel memory resulting in double faults.

   - Fix the section mismatch of the cpu_tss_rw percpu storage caused by
     using a different mechanism for declaration and definition.

   - Two fixes for dumpstack which help to decode entry stack issues
     better

   - Enable PTI by default in Kconfig. We should have done that earlier,
     but it slipped through the cracks.

   - Exclude AMD from the PTI enforcement. Not necessarily a fix, but if
     AMD is so confident that they are not affected, then we should not
     burden users with the overhead"

* 'x86-pti-for-linus' of git://git.kernel.org/pub/scm/linux/kernel/git/tip/tip:
  x86/process: Define cpu_tss_rw in same section as declaration
  x86/pti: Switch to kernel CR3 at early in entry_SYSCALL_compat()
  x86/dumpstack: Print registers for first stack frame
  x86/dumpstack: Fix partial register dumps
  x86/pti: Make sure the user/kernel PTEs match
  x86/cpu, x86/pti: Do not enable PTI on AMD processors
  x86/pti: Enable PTI by default

arch/x86/entry/entry_64_compat.S

@@ -190,8 +190,13 @@ ENTRY(entry_SYSCALL_compat)
 	/* Interrupts are off on entry. */
 	swapgs
 
-	/* Stash user ESP and switch to the kernel stack. */
+	/* Stash user ESP */
 	movl	%esp, %r8d
+
+	/* Use %rsp as scratch reg. User ESP is stashed in r8 */
+	SWITCH_TO_KERNEL_CR3 scratch_reg=%rsp
+
+	/* Switch to the kernel stack */
 	movq	PER_CPU_VAR(cpu_current_top_of_stack), %rsp
 
 	/* Construct struct pt_regs on stack */
@@ -219,12 +224,6 @@ GLOBAL(entry_SYSCALL_compat_after_hwframe)
 	pushq   $0			/* pt_regs->r14 = 0 */
 	pushq   $0			/* pt_regs->r15 = 0 */
 
-	/*
-	 * We just saved %rdi so it is safe to clobber.  It is not
-	 * preserved during the C calls inside TRACE_IRQS_OFF anyway.
-	 */
-	SWITCH_TO_KERNEL_CR3 scratch_reg=%rdi
-
 	/*
 	 * User mode is traced as though IRQs are on, and SYSENTER
 	 * turned them off.

arch/x86/include/asm/unwind.h

@@ -56,18 +56,27 @@ void unwind_start(struct unwind_state *state, struct task_struct *task,
 
 #if defined(CONFIG_UNWINDER_ORC) || defined(CONFIG_UNWINDER_FRAME_POINTER)
 /*
- * WARNING: The entire pt_regs may not be safe to dereference.  In some cases,
- * only the iret frame registers are accessible.  Use with caution!
+ * If 'partial' returns true, only the iret frame registers are valid.
  */
-static inline struct pt_regs *unwind_get_entry_regs(struct unwind_state *state)
+static inline struct pt_regs *unwind_get_entry_regs(struct unwind_state *state,
+						    bool *partial)
 {
 	if (unwind_done(state))
 		return NULL;
 
+	if (partial) {
+#ifdef CONFIG_UNWINDER_ORC
+		*partial = !state->full_regs;
+#else
+		*partial = false;
+#endif
+	}
+
 	return state->regs;
 }
 #else
-static inline struct pt_regs *unwind_get_entry_regs(struct unwind_state *state)
+static inline struct pt_regs *unwind_get_entry_regs(struct unwind_state *state,
+						    bool *partial)
 {
 	return NULL;
 }

arch/x86/kernel/cpu/common.c

@@ -923,8 +923,8 @@ static void __init early_identify_cpu(struct cpuinfo_x86 *c)
 
 	setup_force_cpu_cap(X86_FEATURE_ALWAYS);
 
-	/* Assume for now that ALL x86 CPUs are insecure */
-	setup_force_cpu_bug(X86_BUG_CPU_INSECURE);
+	if (c->x86_vendor != X86_VENDOR_AMD)
+		setup_force_cpu_bug(X86_BUG_CPU_INSECURE);
 
 	fpu__init_system(c);
 

arch/x86/kernel/dumpstack.c

@@ -76,12 +76,23 @@ void show_iret_regs(struct pt_regs *regs)
 		regs->sp, regs->flags);
 }
 
-static void show_regs_safe(struct stack_info *info, struct pt_regs *regs)
+static void show_regs_if_on_stack(struct stack_info *info, struct pt_regs *regs,
+				  bool partial)
 {
-	if (on_stack(info, regs, sizeof(*regs)))
+	/*
+	 * These on_stack() checks aren't strictly necessary: the unwind code
+	 * has already validated the 'regs' pointer.  The checks are done for
+	 * ordering reasons: if the registers are on the next stack, we don't
+	 * want to print them out yet.  Otherwise they'll be shown as part of
+	 * the wrong stack.  Later, when show_trace_log_lvl() switches to the
+	 * next stack, this function will be called again with the same regs so
+	 * they can be printed in the right context.
+	 */
+	if (!partial && on_stack(info, regs, sizeof(*regs))) {
 		__show_regs(regs, 0);
-	else if (on_stack(info, (void *)regs + IRET_FRAME_OFFSET,
-			  IRET_FRAME_SIZE)) {
+
+	} else if (partial && on_stack(info, (void *)regs + IRET_FRAME_OFFSET,
+				       IRET_FRAME_SIZE)) {
 		/*
 		 * When an interrupt or exception occurs in entry code, the
 		 * full pt_regs might not have been saved yet.  In that case
@@ -98,11 +109,13 @@ void show_trace_log_lvl(struct task_struct *task, struct pt_regs *regs,
 	struct stack_info stack_info = {0};
 	unsigned long visit_mask = 0;
 	int graph_idx = 0;
+	bool partial;
 
 	printk("%sCall Trace:\n", log_lvl);
 
 	unwind_start(&state, task, regs, stack);
 	stack = stack ? : get_stack_pointer(task, regs);
+	regs = unwind_get_entry_regs(&state, &partial);
 
 	/*
 	 * Iterate through the stacks, starting with the current stack pointer.
@@ -120,7 +133,7 @@ void show_trace_log_lvl(struct task_struct *task, struct pt_regs *regs,
 	 * - hardirq stack
 	 * - entry stack
 	 */
-	for (regs = NULL; stack; stack = PTR_ALIGN(stack_info.next_sp, sizeof(long))) {
+	for ( ; stack; stack = PTR_ALIGN(stack_info.next_sp, sizeof(long))) {
 		const char *stack_name;
 
 		if (get_stack_info(stack, task, &stack_info, &visit_mask)) {
@@ -140,7 +153,7 @@ void show_trace_log_lvl(struct task_struct *task, struct pt_regs *regs,
 			printk("%s <%s>\n", log_lvl, stack_name);
 
 		if (regs)
-			show_regs_safe(&stack_info, regs);
+			show_regs_if_on_stack(&stack_info, regs, partial);
 
 		/*
 		 * Scan the stack, printing any text addresses we find.  At the
@@ -164,7 +177,7 @@ void show_trace_log_lvl(struct task_struct *task, struct pt_regs *regs,
 
 			/*
 			 * Don't print regs->ip again if it was already printed
-			 * by show_regs_safe() below.
+			 * by show_regs_if_on_stack().
 			 */
 			if (regs && stack == &regs->ip)
 				goto next;
@@ -199,9 +212,9 @@ next:
 			unwind_next_frame(&state);
 
 			/* if the frame has entry regs, print them */
-			regs = unwind_get_entry_regs(&state);
+			regs = unwind_get_entry_regs(&state, &partial);
 			if (regs)
-				show_regs_safe(&stack_info, regs);
+				show_regs_if_on_stack(&stack_info, regs, partial);
 		}
 
 		if (stack_name)

arch/x86/kernel/process.c

@@ -47,7 +47,7 @@
  * section. Since TSS's are completely CPU-local, we want them
  * on exact cacheline boundaries, to eliminate cacheline ping-pong.
  */
-__visible DEFINE_PER_CPU_SHARED_ALIGNED(struct tss_struct, cpu_tss_rw) = {
+__visible DEFINE_PER_CPU_PAGE_ALIGNED(struct tss_struct, cpu_tss_rw) = {
 	.x86_tss = {
 		/*
 		 * .sp0 is only used when entering ring 0 from a lower

arch/x86/kernel/stacktrace.c

@@ -102,7 +102,7 @@ __save_stack_trace_reliable(struct stack_trace *trace,
 	for (unwind_start(&state, task, NULL, NULL); !unwind_done(&state);
 	     unwind_next_frame(&state)) {
 
-		regs = unwind_get_entry_regs(&state);
+		regs = unwind_get_entry_regs(&state, NULL);
 		if (regs) {
 			/*
 			 * Kernel mode registers on the stack indicate an

arch/x86/mm/pti.c

@@ -367,7 +367,8 @@ static void __init pti_setup_espfix64(void)
 static void __init pti_clone_entry_text(void)
 {
 	pti_clone_pmds((unsigned long) __entry_text_start,
-			(unsigned long) __irqentry_text_end, _PAGE_RW);
+			(unsigned long) __irqentry_text_end,
+		       _PAGE_RW | _PAGE_GLOBAL);
 }
 
 /*

security/Kconfig

@@ -56,6 +56,7 @@ config SECURITY_NETWORK
 
 config PAGE_TABLE_ISOLATION
 	bool "Remove the kernel mapping in user mode"
+	default y
 	depends on X86_64 && !UML
 	help
 	  This feature reduces the number of hardware side channels by